How many joules of energy are stored in the battery

Assignment Help Electrical Engineering
Reference no: EM13225686

A double-A (AA) rechargeable battery is rated at 1.2V, 2100mAh (mili-amp hours)

1- how many coulombs of charge can this battery hold?

2- how many joules of energy are stored in the battery?

3- if the battery is used to power a water pump at 80% efficiency, how much water could it pump while maintaining a pressure of 100 J/m^3?

Reference no: EM13225686

Questions Cloud

Do specify the requirements on the adc : A calibrated RTD with ALPHA = 0.0041/°C, R = 306.5 Ohms at 20°C, and PD = 30 mW/°C will be used to measure a critical reaction temperature. Temperature must be measured between 50° and 100°C with a resolution of at least 0.1°C.
All male athletes are self-centered and sexist : Alexis believes that all male athletes are self-centered and sexist. Her beliefs are an example of:
Explain ammonium nitrate to a solution of ammonium hydroxide : Illustrate with a net ionic equation for each of the following how the pH would increase, decrease, or stay the same with the indicated changes: (b) Adding ammonium nitrate to a solution of ammonium hydroxide
A description of how a specific business requirement : A description of how a specific business requirement would drive the project's creation and use
How many joules of energy are stored in the battery : A double-A (AA) rechargeable battery is rated at 1.2V, 2100mAh (mili-amp hours) 1- how many coulombs of charge can this battery hold 2- how many joules of energy are stored in the battery
What would be the percentage change in the multifactor : If output remains the same but Osborne is able to reduce the labor hours used to 8,000, what would be the percentage change in the multifactor productivity.
Explain the molar solubility of agcl : How many grams of CaCO3 will dissolve in 2.8 multiplied by 102 mL of 0.050 M Ca(NO3)2? Calculate the molar solubility of AgCl in a solution made by dissolving 10.0 g of CaCl2 in 4.50 L of solution.
Important for managers to have a working knowledge : Why is it important for managers to have a working knowledge of perception and attribution?
What are the special challenges in each area : What are the special challenges in each area and what would be the effects on employees and employers if the challenges were not addressed?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How much coal did we burn

The residential sector of PA consumed about 150.6x1012 Btu of electricity (www.eia.doe.gov). Assuming all of this energy comes from bituminous coal with a heating value of 14,000 Btu/lb. How MUCH coal did we burn?

  Build a home security system circuit

Build a home security system circuit using this program. The system must include a door sensor,window sensor, smoke detector, water leak sensor, a motion detector.

  What is the symbol rate and what is the bandwidth

What is the symbol rate and what is the bandwidth occupied by the 16-QAM signal? The link must maintain a BER no higher than 10^-6. What is the minimum CNR in the receiver to meet this requirement?

  What is the angle at each tip of the cottage

The cross section of a cottage 20 ft wide is an isosceles triangle. If the slope of a side is 1.75 and there is a second floor 9 feet above the ground floor,What is the angle at each tip of the cottage?

  Basic column control

The basic column control system shown in Figure is somewhat more complicated than the basic neutralizer control system

  Determine the transfer function of this process in the s

Assume the initial state is steady (y = 0 at t = -0) a) Determine the transfer function of this process in the s domain. b) If the input is a ramp change in u(t) = 4t, determine the value of y(t) when t = 10s.

  Write a ladder logic program needed to implement

Write a ladder logic program needed to implement each of the following (assume inputs A, B and C are all normally open toggle switches).

  Define static electricity

Define static electricity and State five sources of static electricity and Describe three methods used to reduce hazards due to static electricity

  What are the positive and negative implications

What are the positive and negative implications of wireless energy?

  How to evaluate power dissipated in the components

how to evaluate power dissipated in the components of an RLC series circuit by using matlab software?

  Computing peak frequency deviation and carson''s rule

Calculating peak frequency deviation and Carson's rule bandwidth, A baseband signal has a frequency range from 50 Hz to 15.0 kHz. The signal is transmitted using frequency modulation. The FM transmitter has a modulation constant of 100 kHz per vol..

  Explain current and average power delivered to the load

Current and average power delivered to the load, A load has a 20 ohm resistor and a 4 henry inductor connected in series. It is connected to a power source with v(t)= 100cos50t

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd