Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Impulse Responses of LTI systems can be physically found by inputting
\(x[n] = \delta[n]\)
to the system and measuring the output. Assume that during the process, we inadvertently input
\(x[n] = \delta[n] + \delta[n-1]\)
instead and observed the output to be y[n] = u[n]. Can we still figure out the impulse response? And if so, what is it?
The instantaneous power p into a one port containing resistors and inductors has maximum value 100(1+sqrt2) W and minimum value 100(1-sqrt2)W. (note that instantaneous power is measured in W, and it contains various contributions
Consider an 8-user CDMA system. The data vector of all users is given by [1,1,1,1,-1,-1,-1,1]. Find the total transmit signal.
Reduce the equation to the slope-intercept form and give the slope and the y-intercept.
Consider a virtual memory system that can address a total of 232 bytes. You have unlimited hard drive space, but are limited to only 8 MB of semiconductor (physical) memory. Assume that virtual and physical pages are each 4 KB in size.
Resistance of Headlights, A 24-volt automotive battery is connected to two headlights, such that the two loads are in parallel
A 100 mile , 300kV, 60Hz transmission line has a reactance of 0.8 ohm per mile and a distributed capacitance of 200,000 ohms per mile. Draw a equivalent circuit phase at the sender end when the receiver is open. What is the reactive power supplied..
The voltage across the load must remain between 4.7 and 5.0 V for all values of load current. Design a voltage-divider network to supply the load. You may assume that resistors of any value desired are available.
You have a 10 nH inductor. What value of capacitor should you put in series with the inductor to achieve an impedance of Z=j50 ohm at f=1.0 GHz
Calculate the minimum value of Vd if the power flow through the converter is 5 kW (a) from the ac to the dc side and (b) from the dc to the ac side.
Three towns A, B & C are situated at the corners of an equivalent triangle of side 30 km. It is proposed to supply power to extent of 30 MW, 10 MW, 20 MW to A, B & C respectively from one substation. Where should substation be located to minimize ..
A rectangular chip has a top surface of 0.5 cm by 2 cm cooled by air at 20 oC with h = 150 W/m2.K. There are also 16 connector pins, 1 mm wide, 0.5 mm thick, 6 mm long and k = 60 W/m.K attached to a circuit board at 30 oC.
The design must show all stages used in its development and must be implemented and tested in PSpice and suitable timing waveforms produced.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd