Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A half-wave rectifier circuit with a 1-Kwload operates from a 12-v(rms) 60-Hz household a 5-to 1 transformer having a center-tappedsecondary winding. It use two silicon diodes that can be modeled tohave a 0.7-v drop for all currents. For what fraction of acycle does each diode conduct, and what is the average output voltage?
A wafer 100mm in diameter is mounted in an electron-beam evaporation system in which the spherical radius is 40cm. Use Eq. 6.7 to estimate the worst-case varation in film thickness between the center and edges
A calibrated RTD with ALPHA = 0.0041/°C, R = 306.5 Ohms at 20°C, and PD = 30 mW/°C will be used to measure a critical reaction temperature. Temperature must be measured between 50° and 100°C with a resolution of at least 0.1°C.
A half-wave rectifier circuit with a 1-k ohm load operates from a 120-V (rms) 60-Hz household supply through a 10-to-1 step-down transformer. It uses a silicon diode that can be modeled to have a 0.7-V drop for any current.
Show that a Miller integrator implemented with an op amp with open-loop gain A0 has a low-pass STC transfer function. What is the pole frequency of the STC function. How does this compare with the pole frequency of the ideal integrator.
A Y-connected three phase supply has a balanced voltages of 110e^j0, 110e^(j2/3) and , 110e^(j4/3). The corresponding impedances on the Y-connected load are 30, 30+j40 and 40+j30 ohm.
A dc separately excited generator runs at 1200 rpm. the rated current and voltages are 100 A at 240 V. The armature resistance is 0.15 (ohms). The open circuit magnetization characteristics at 1200 rpm are
What is the function of the enable control input of a tri-state buffer. If the output of two or more tri-state buffers is connected to each other, what is the restriction on enable control input lines.
A) Convert the following Switch Algebra function into NOR-NOR implementation (Draw the logic and then convert it into NOR-NOR): F = W X + Y Z +W Y Z B) Convert the following Switch Algebra function into NAND-NAND implementation
Design and simulate a power supply that takes line voltage and produces a 15V output with less than .5% ripple voltage.
Compare the field at the center of a Helmholtz coil pair and at the center of a solenoid, if both use the same total length of wire and carry the same current.Take the solenoid length equal to the spacing between the Helmholtz coils
A series circuit consists of a voltage source and four resistors (R1=1k-ohm; R2=30-ohm; R3=470-ohm; R4=2k-ohm). The resistor of 1k-ohm has a voltage of V1=3V across its terminals. a) Find the current out of the voltage source.
A computer employs RAM chips of 256 x 8and ROM chips of 1024 x 8. The computer system needs 2K bytes of RAM, 4K bytes of ROM, and four interface units, each with four registers. A memory-mapped I/0 configuration is used.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd