For an adiabatic in viscid flow

Assignment Help Mechanical Engineering
Reference no: EM13701025

For an adiabatic in viscid flow, write the entropy equation in general coordinate-independent form and in Cartesian coordinates. What does the equation express? Can we say that entropy is constant in an entire such flow (explain your answer)?

Reference no: EM13701025

Questions Cloud

Determine the tension in the cable : A 8 m rectangular gate shown below weighing 200 N is held in place by a horizontal flexible cable as shown in the figure below. Water acts against the gate which is hinged (frictionless hinge) at point A. determine the tension in the cable.
An escape artist is chained and placed : An escape artist is chained and placed in a 1 m x 1 m x 2 m box in which one side is hinged at the top of the box. The box is lowered into water until the top surface is just below the water surface. At that point, an 8 cm diameter hole is opened 0.7..
Where are the respective reference points of particles : Two particles A and B start from rest at the origin s=0 and move along a straight line such that a_A=(6t - 3) ft/s^2 and a_B=(12t^2 - 8) ft/s^2, where t is in seconds. Where are the respective reference points of particles A and B? What are the direc..
Using constant specific heats at room temperature : A closed gas turbine unit uses neon as the working fluid. There are two stages of compression with inter cooling from 480kPa and 290K to a maximum pressure of 2.75MPa with an intermediate pressure of 1149kPa. The regenerator has an effectiveness of 6..
For an adiabatic in viscid flow : For an adiabatic in viscid flow, write the entropy equation in general coordinate-independent form and in Cartesian coordinates. What does the equation express? Can we say that entropy is constant in an entire such flow (explain your answer)?
What range of input voltages would produce : An 8-bit ADC with a 10.0-V reference has an input of 3.797 V. Find the digital out- put word. What range of input voltages would produce this same output? Suppose the output of the ADC is 101101112. What is the input voltage?
Find the output voltage produced : A 6-bit DAC has an input of 1001012 and uses a 10.0-V reference. a. Find the output voltage produced. b. Specify the conversion resolution.
The volume flow rate at the exit of the pipe : Carbon-dioxide gas at 3MPa and 500 K flows steadily in a pipe at a rate of 0.4kmol/s. Determine a) the volume and mass flow rates and the density of carbon dioxide at this state. If CO2 is cooled at a constant pressure as it flows in the pipe so that..
A rich benefactor calls a meeting with two deans : A rich benefactor calls a meeting with two Deans. The benefactor wishes to make a $100 donation to the two schools, but requires the deans to engage in the following bargaining game to divide the money. First the Dean L offers the Dean R a porti..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  At the inlet the velocity is 40 fts and the pressure 15

liquid water flows isothermally at 75of through a one-inlet one-outlet duct operating at steady state. the ducts inlet

  If an automobile of mass 2 mg rounds this curve at 100 kmh

a curve of radius 200m on a level road is banked correctly for a speed of 65 kmh. if an automobile of mass 2 mg rounds

  The pressure inside the cylinder is held constant at 300

a mass of 15kg of air in a piston-cylinder device is heated from 25 to 77 degrees c by passing current through a

  How will notches and holes affect the deflection

How will notches and holes affect the deflection of a cantilever beam? ie. increase or decrease? (Please provide citations)

  An appropriate correlation for heat transfer by natural

an appropriate correlation for heat transfer by natural commotion from a honzontal pipe to the atmosphere isnu

  Tomato juice having a concentration of 12 wt solids is

tomato juice having a concentration of 12 wt solids is being concentrated to 25 solids in a film-type evaporator. the

  What is the concentration of fecl3 in a solution

What is the concentration of FeCl3 in a solution prepared by dissolving 20.0 g of FeCl3 in enough water to make 275 mL of solution?

  Nitrogen at 900 kpa and 300 degree c is expanded

nitrogen at 900 kpa and 300 degree c is expanded adiabatically in a closed system to 100 kpa. determine the minimum

  Determine the heat transfer characteristics

To determine the heat transfer characteristics of a cylinder under cross flow conditions when the cylinder is isolated.

  What would your answer be if the convection heat transfer

it is well known that wind makes cold air feel much colder as a result of the wind-chill effect which is due to the

  A steam turbine is operated ith an input temp of 800c and

a steam turbine is operated ith an input temp of 800c and exhaust temp of 150c. what is the maximum amount of work the

  A hydraulic power generation turbine-generator plant is

a hydraulic power generation turbine-generator plant is installed at a site 200 m below the free surface of a large

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd