Finding out the op level from an attenuator of know ip

Assignment Help Electrical Engineering
Reference no: EM13141514

Determining the o/p level from an attenuator of know i/p

An attenuator has an attenuation of 10 dB over the frequency range 10 MHz to 1.0 GHz. A signal at the input of the attenuator has a frequency of 257 MHz and a power level of 10 dBW. What is the power level at the output of the attenuator in dBm?

Reference no: EM13141514

Questions Cloud

What is the total amount of salt dissolved : The addition of 6 g of salt to a sample of pure water causes its freezing point to be reduced from 0°C to -1.5°C. After an additional amount of salt is dissolved in the solution
What is the amount of ending inventory : Chess Top uses the periodic inventory system. For the current month, the beginning inventory consisted of 200 units that cost $65 each. During the month, the company made two purchases: 300 units at $68 each and 150 units at $70 each. Chess Top al..
Calculate margin of error for confidence interval for mean : What critical value t* from table D should be used to calculate the margin of error for a confidence interval for the mean of the population in each of the following situations?
How much would the crow manufacturing total income : Based on Crow Manufacturing's data in Exercise 24-20, assume that a transfer price of $110 has been established and that 40,000 units of materials are transferred, with no reduction in the Materials Division's current sales. How much would the Cr..
Finding out the op level from an attenuator of know ip : Determining the o/p level from an attenuator of know i/p, An attenuator has an attenuation of 10 dB over the frequency range 10 MHz to 1.0 GHz
What mass of ccl4 will be formed : What mass of CCl4 will be formed if 1.20 moles of methane react with 1.55 moles of chlorine?
Realistic that a commitment to continuous improvement : 200 words..Is it realistic that a commitment to continuous improvement could actually replace operational controls? Strategic controls?
Find an equation of the tangent plane : Find an equation of the tangent plane to the parametric surface r(u,v) = (u*cos(v), u*sin(v), v) at the point defined by u=1, v=pi.
Find the mean income with a standard deviation : She surveys 100 randomly selected families and finds the mean income to be $96,321 with a standard deviation of $9555.With a0.05, is she correct?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain power dissipation problems

Power Dissipation Problems, A signal generator outputs a sine wave signal with a frequency of 1000 Hz and an rms voltage of 20.0 V. The output of the spectrum analyzer is connected to a 200 ohm resistor.

  Performance analysis of 16 bit by16 bit mac design

Performance Analysis of 16 Bit by16 Bit MAC design using 5:3 Compressors - 3:2 counters and 4:2 compressors have been widely used for multiplier implementations.

  Define maximum number and the geometric mean

I started writing a program and need help. I need to be able to enter up to 15 numbers and output the minimum number, maximum number and the geometric mean.

  Explain understanding low high and band pass filters

Understanding low, high and band pass filters, A signal in the IF section of an FM radio receiver occupies the frequency band 10.61 MHz to 10.79 MHz. Compute the bandwidth of this signal.

  Define power systems theory definitions and formulas

Power Systems Theory Definitions and Formulas, Define, (a) The fault level of a system or unit in a system, (b) base MVA

  Define a saturated npn transistor

A saturated npn transistor has a base to emitter applied voltage of 0.6V. The collector to emitter voltage is 0.2V. The collector current is 12mA

  Define a sinusoidal voltage has a maximum value

A sinusoidal voltage has a maximum value of 100V, and the value is 10V at t=0. The period is T=1ms. Determine v(t)

  Define design bandpass filter of ''sallen and key'' topology

Design a bandpass filter of 'Sallen and Key' topology and having the following characteristics fo = 3.3 kHz, Q = 2.2

  Define cellular operator designs a network reuse pattern

TDMA has 416 frequencies in one of the cellular license bands. If a cellular operator designs a network with a 5/15 reuse pattern, how many frequencies per cell (sector) can be supported? ( ignore control channels)

  Problem on transmission line operation

Evaluate the TL parameters. Include the effect of the earth as ideal. Do not incorporate the effect of the shield wires.

  Explain what is the byte stored at address

Using the table, what is the byte stored at address 2F? Using the table, what is the byte stored at address 33?

  Define a digital signaling system is required to operate

A digital signaling system is required to operate at 9600 bps. If a signaling element encodes a 8-bit word, what is the minimum required bandwidth of the channel?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd