Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A three-phase, ac/dc converter is excited by a three-phase source of 480 V (rms and line-to-line). Compute the following:
a. The rms volatge across the load when the triggering angle is 30 degrees
b. The average voltage across the load when the triggering angle is 140 degrees. Keep in mind that the conduction is incomplete when the triggering angle is greater than 140 degrees.
An overhead line with an inductance of 1.33 mH/km and capacitance of 8.34 nF/km is connected to an underground cable with an inductance of 0.266 mH/km and capacitance of 166 nF/km.
A waveform generator has been setup with a square wave output at 4.0kHz with a 81% duty cycle. If the peak-to-peak output amplitude has been set to 6.0V, with an offset of -1.0V, what is the maximum voltage of the output waveform
Build a home security system circuit using this program. The system must include a door sensor,window sensor, smoke detector, water leak sensor, a motion detector.
Determine the value of the output voltage due to the voltage source only (Vol), and due to the current source only (V02).
Vary as square root-application, The frequency f of vibration of a wire varies directly as the square root of the tension T of the wire
Simplify the following circuit. Line A goes into an INVERTER, then into a NAND Gate, then into an OR Gate, then travels into another NOR Gate.
Assume that we try to predict this sequence with a BHT using one-bit counters. The counters in the BHT are initialized to the N state. Which of the branches in this sequence would be mis-predicted?
Discuss how the angle of the incident light affected the solar cell? How could solar cell designs and/or installations be designed to counter this affect?
The angle of departure is defined as 180 degrees plus the phase angle of GH computed at the complex pole, but ignoring the contribution of that particular pole.
The signal to noise ratio at the receiver is required to be at least 17 dB. The average noise power at the receiver is 1 mW. The cable loss between the transmitter and the receiver is 2.5 dB/km
1) Modern technology has produced a small 1.5-volt alkaline battery with a nominal stored energy of 150 joules. For how many days will it power a calulator that draws a 2-mA current 2)The current entering the positive terminal of an element is
The purpose of this project is to design a device that would remotely control (from a Bluetooth-enabled mobile phone for instance) at least two actuators (e.g. relays and switches).
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd