Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An SSB generator has a 9 MHz carrier and is used to pass voice frequencies in the 300- to 3300-Hz range. The lower sideband is selected. What is the approximate center frequency of the filter needed to pass the lower sideband?
A 100 mile , 300kV, 60Hz transmission line has a reactance of 0.8 ohm per mile and a distributed capacitance of 200,000 ohms per mile. Draw a equivalent circuit phase at the sender end when the receiver is open. What is the reactive power supplied..
Once a week a wagon driver leaves his hut and drives his wagon to the river dock to pick up supplies for his town. At 4:05 PM, one-fifth of the way to the dock, he passes the Temple. At 4:15 PM, one-third of the way, he passes the Preetam-Da-Dhaba..
The length of a wire of a potentiometer is 100 cm, and the e.m.f. of its stand and cell is E volt. It is employed to measure the e.m.f. of a battery whose internal resistance is 0.5 ohm. If the balance point is obtained at l =3..
calculate the short-circuit current of a three-phase delta-wye connected transformer if the short circuit occurs between phase A and the neutral at the low voltage side, and the transformer is supplied by a 13 kV line-to-line voltage.
a sound distribution system has the following outputs 10 watts at 8ohms,5watts at 4 ohms, 15 watts at 16 ohms and 2 watts at 4 ohms if the input to the amplifier is 20 millivolts at 600 ohms how much gain in decibels will be required of the amplif..
a 14-bit successive approximation adc is used to sample a signal that has a full-scale range of 8V and a clock frequency of 12 MHz and a jitter of 50ns.initially this is used without a sample and hold amplifier.
Assume the existence of the following Java GUI application. There are two text fields for user input. The first JTextField variable is named res1 and is used to input a resistance value in ohms. The second JTextField variable named tol is used to ..
Assuming the bandgap of GaAs, Eg1 = 1.424 eV and that of AiAs, Eg2 = 2.671 eV, find the required AI - fraction x in AIxGa1As compound to fabricate the material for red light emission with the wavelength lambda = 652 nm.
What is the attenuation per octave between 1 kHz and 10 kHz? What is the increase in attenuation between 5 kHz and 10 kHz?
A BJT is operated in a 50ohm circuit 1.5Ghz. FOr the bias conditions of Collector Current - 4mA and Collector-Emittor Voltage = 10V. The manufacturer provides the S-parameters in magnitude and angles (in degrees) as follows. S11 = 0.7
antialiasing and anti-imaging active filter Sampling rectangular pulses (sampling clock) set as the following. Vp (pulse value) = -5 volts, Period: 0.125 ms, Pulse width 0.02 ms Sinusoidal voltage source set as the following: Frequency = 1000 Hz , Vp..
The total current in a semiconductor is constant and is composed of electron drift current and hole diffusion current. The electron concentration is constant and is equal to 10^17 cm^-3. The hole concentration is given by p(x)
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd