Find values of resistance-voltage and current for total

Assignment Help Electrical Engineering
Reference no: EM13281193

find values of resistance, voltage, and current for total and all 3 voltage drops where only certain information is given out of three voltage drops info given total voltage is 12v, resistance 1 is 2.2KO, resistance 2 is 1.6KO, and resistance 3 is 1.2KO

Reference no: EM13281193

Questions Cloud

Calculate electron-hole and intrinsic carrier concentrations : A semiconductor has Nc=10^19 cm^-3, Nv=5x10^18 cm^-3 and Eg=2eV. If it is doped with 2x10^17 acceptors (fully ionized), calculate the electron, hole and intrinsic carrier concentrations at 627 C. Sketch the simplified band diagram, showing the pos..
How much work does the elevator do : An elevator is able to raise 9,800 N to a height of 22 m in 14 s. How much work does the elevator do
Compute the value of the reverse rate constant : For a certain reaction, = 8.38×10?4 and 9.24×10?5 . Calculate the value of the reverse rate constant, , given that the reverse reaction is of the same molecularity as the forward reaction.
Mass per unit volume of substance is called density : The mass per unit volume of a substance is called density (density = mass/volume). Arrange the following in order of increasing density - air, exhaust from chimney, honey, water, chalk, cotton, and iron.
Find values of resistance-voltage and current for total : find values of resistance, voltage, and current for total and all 3 voltage drops where only certain information is given out of three voltage drops info given total voltage is 12v, resistance 1 is 2.2KO, resistance 2 is 1.6KO, and resistance 3 is..
How fast will the payload be traveling : At NASA's Zero Gravity Research Facility in Cleveland, Ohio, experimental payloads fall freely from rest in an evacuated vertical shaft through a distance of 132 m. How fast will the payload be traveling when it reaches the bottom of the shaft
What is the electron concentration and conductivity : a) A Si is doped with 10^17 boron atom/cm3. What is the electron concentration n0 at 300K. What is conductivity. b) A Ge sample is doped with 3x10^3 Sb atoms/cm3. Using the requirements of space charge neutrality
What is the velocity of the tackle before the collision : A running back with a mass of 82 kg and a velocity of 9 m/s (toward the right) collides with, What is the velocity of the tackle before the collision
Destructive energy of an earthquake is measured : Name the scale on which the destructive energy of an earthquake is measured. An earthquake measures 3 on this scale. Would it be recorded by a seismograph? Is it likely to cause much damage?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define interpreting frequency domain signal spectrum

Interpreting frequency domain signal spectrum to time domain, A spectrum analyzer is connected to an unknown signal. The spectrum analyzer displays the voltage level of signals in volts vertically and frequency horizontally.

  Calculate metallurgical junction depths of boron substrate

The surface concentration is fixed at N0=1.8e20/cm^2 when diffusing boron into a uniformly doped n-type substrate. The atomic diffusion constant for boron in Si at the temperature of 950 C is 3.0e-15 cm^2/s.

  Make a program that will read a file from a disk

C++ Program Help, make a program that will read a file from a disk and will take the first letter of each word and and make that into a sentence.

  Write general form of natural response for capacitor voltage

Consider a source-free parallel RLC circuit having alpha =10^8 s^-1, omega-sub-zero = 10^3 rad/s, and omega-sub-zero * L = 5 ohm. a) Show that the stated units of omega-sub-zero * L are correct. b) Compute s_1and s_2.

  Why it needs time more then 5-tau to become steady state

How to calculate the transient time need for the simple passive low pass filter Why it needs the time more then 5-Tau (RC) to become a steady state

  What causes the current gain to decrease

What causes the current gain to decrease both in the case of a low collector current and at a high collector current?

  Find the output resistance of the amplifier

An amplifier has an open-circuit voltage gain of 100. With a 10-KOhm load connected, the voltage gain is found to be only 80. Find the output resistance of the amplifier.

  Design a simple circuit diagram to complete the tasks

Design a simple circuit diagram,to complete the following task.1)Green lamp light up when the system is ON. 2)Once the pushbutton is pressed, Green Lamp turns OFF and Red Lamp turns ON,Motor starts to spin.3) Once the sensor detect the motor rotat..

  Verify loop analysis method by multisim simulation

Scenario/Summary: At least two of the following simulations must be attempted by the student. Verify Loop Analysis Method by MultiSim simulation Verify Superpposition Theorem Method by MultiSim simulation

  Determine the time-dependent voltage and current at the load

A 200-MHz voltage source with output Vg = 200 V 0 and internal impedance of 100 Ω is connected to the input of the line. Determine the time-dependent voltage and current at the load, and the average power delivered to the load.

  What is the frequency of the instantaneous power

1-If the voltage is 106 V cos(84 rad/s t + 46°) and the current is 9 A cos(84 rad/s t + 72°), what is the frequency of the instantaneous power. 2- If the voltage is 101 V cos(47 rad/s t + 11°) and the current is 16 A cos(47 rad/s t + 67°).

  What are the different methods used in frequency response

what are the different methods used in frequency response analysis

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd