Find the transfer function of the system of equation

Assignment Help Electrical Engineering
Reference no: EM13283471

The equation y[n] - p y[n-1] = x[n] can be used to describe thevalue y[n] of a new investment by setting p = 1 + r/100 where r is the interest rate per period, expressed inpercent.

Find the transfer function of this system and determine whether itcan be both stable and causal.

Reference no: EM13283471

Questions Cloud

What are meanings of weights in wacc calculation : Why we think the capital from retained earnings is not free? When we compute the cost of this type of capital, the influence of taxation is considered or not? Explain.
Find the value for required q for the first filter : Find the value for required Q for the first filter.
What is the worst-case npv : Suppose the projections given for price, quantity, variable costs, and fixed costs are all accurate to within ±14 percent. What is the worst-case NPV?
Explain the difference between tdm and tdma. : Explain the difference between TDM and TDMA.
Find the transfer function of the system of equation : The equation y[n] - p y[n-1] = x[n] can be used to describe thevalue y[n] of a new investment by setting p = 1 + r/100 where r is the interest rate per period, expressed inpercent.
What factors can affect the resistance of the human body : Describe what causes the human body to have resistance and what factors can affect the resistance of the human body.
What ethical issues are presented by allisons behavior : What ethical issues are presented by Allisons behavior? How can they be resolved? Thoroughly explain your answer. Fully describe the applicable laws and then apply them to the material facts. Explain your analysis. If you make assumptions of fact, fu..
What form of linear distortion is introduced by the channel : Phase distortion - the phase response is not linear with frequency inside the frequency band of interest. Different frequency components are subject to different delay in passing through the system.
Calculate the noise specification : 1. Calculate SNR(dB) given a noise specification of 680nV

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the peak-to-peak output voltage-vpp

A certain sawtooth generator has the following parameter values: Vin: 3v, R: 4.7kohm, C:0.001uf. Determine its peak-to-peak output voltage if the period is 10 us. What is the Vpp

  Calculate the energy stored in the inductor at t

R- 1k ohm; L=1nH for the circuit represented in Fig. 8.1, and with the knowledge that i(0) = -3mA: a) Write an expression for i(t) valid for all t>=0 b) Compute i(t) at t=0, t=1ps, 2ps, and 5ps

  Which design would choose using maximax rule

Consider the following matrix of expected profits (in units of $1K) versus potential future material price scenarios (P1 - P5), for five different designs (D1 - D5): P1 P2 P3 P4 P5 D1 10 20 30 40 50 D2 20 25 25 30 35

  Determine a suitable sampling frequency

Determine a suitable sampling frequency. Design a notch filter to remove the 50Hz component, paying particular attention to any assumptions you have made in the design.

  How much weight can the crane continue to support power

A stepper motor is being used to move a crane. The motor has the following properties: Holding torque = 2 m.kg, dynamic torque = 1.5 m.kg, and detent torque = 0.5 m.kg. Through a 1:5 gear, the motor (motor connected to the smaller gear)

  What is the childs speed three-quarters of the way down

A 34.3 kg child starting from rest slides down a water slide with a vertical height of 20.3 m.  (a) What is the child's speed halfway down the slide's vertical distance (b) What is the child's speed three-quarters of the way down

  How the voice message is best received

You have a shortwave AM receiver (just an AM receiver that has the capability to receive signals in the FM frequency band) that receives an NBFM voice signal at some carrier frequency. You notice, however, that while the signal strength is maximiz..

  Determine turns required in each phase of a star connected

Determine the turns required in each phase of a star connected alternator operating on an 11 kV 50 Hz system if it has a flux per pole of 0.38 Wb, pitch factor of 0.95 and breadth factor of 0.98

  Find the ratio between the power delivered to the same motor

However, for short-time operation, a delta connection can be used at the nominal wye voltage. Find the ratio between the power delivered to the same motor in the wye and delta connections.

  Find the normal force exerted by the pavement on the tires

A curve of radius 159 m is banked at an angle of 11°. An 810-kg car negotiates the curve at 93 km/h without skidding. Neglect the effects of air drag and rolling friction. Find the normal force exerted by the pavement on the tires.

  What is the total impeadance of the combined three loads

Three loads are connected in parrallel across a 250 Vrms line. Load 1 absorbs 16 kW and 18 kVAR. Load 2 absorbs 10 kVA with a power factor of 0.6 leading. Load 3 absorbs 8 kW with a power factor of 1.

  Which rating would be used for a minimum safety margin

A certain type of power resistor comes in the following rating:3w,5w,8w,12w,20w. your particular application requires a resistor that can handle approximately 8w.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd