Find the total friction losses and piping system

Assignment Help Mechanical Engineering

Reference no: EM13718036

Water is pumped from a lake at ambient pressure and temperature to an elevation of 15 m through a pipe of 2-cm diameter galvanized iron at a flow rate of 0.00366 m³ /s. Assume the discharge is to open atmosphere. The pipe is 70 m long and has 2- 90^o threaded bend and one 45^o regular elbow, and a gate valve that is half closed.

a. Draw the piping system

b. Find the total friction losses

c. Find the total minor losses

d. Can the minor losses be neglected?

e. Calculate the pump power

Reference no: EM13718036

Questions Cloud

Maximum and minimum temperatures for the cycle : One kilogram of air as an ideal gas executes a Carnot power cycle having a thermal efficiency of 60%. The heat transfer to the air during the isothermal expansion is 40 kJ. At the beginning of the isothermal expansion, the pressure is 700 kPa and the..

Component in the shape of a large rectangular sheet : A component in the shape of a large rectangular sheet is made from AL-7075-T651. It carries uniform axial stress that may reach up to 50% of its yield strength. Assuming worst case scenario, what is the largest edge crack that can be allowed?

Design a single pass shell and tube type heat exchanger : Design a single pass shell and tube type heat exchanger which requires mh = 25 kg/s with Th,i = 30 C and mc = 75 kg/s with Tc,i = 20 C. What heat transfer rate is obtained using 150 2 m tubes (ID = 16 mm and OD = 19 mm with kw = 400 W/mK).

Coil for controlling the fermentation temperature : A helical cooling coil of 150 m in length and 12 cm in diameter inside a fermenter was used to maintain the temperature of a fermentation broth at 37 degrees C. When the coil was totally clean, only 15 kg/s cooling water at 12 degrees C were required..

Find the total friction losses and piping system : Water is pumped from a lake at ambient pressure and temperature to an elevation of 15 m through a pipe of 2-cm diameter galvanized iron at a flow rate of 0.00366 m3 /s. Assume the discharge is to open atmosphere. The pipe is 70 m long and has 2- 90o ..

Air enters turbine operating at steady state with pressure : Air enters a turbine operating at steady state with a pressure of 75 psi a temperature of 800°R and a velocity of 400ft/s. At the turbine exit the conditions are 15psi, 600°R and 100 ft/s. Heat transfer from the turbine to its surroundings takes plac..

The specific work of the compressor : An air compressor compresses air from 1 bar and 300 K to 5 bar and 540 K. The velocity at the inlet is 70 m/s and the velocity at the exit is 150 m/s. If To = 300 K and Po = 1bar.

Final state of water assuming the process to be adiabatic : A piston held by a pain in an insulated cylinder, contains 2 kg water at 100 degree C, quality 95%. The piston has a mass of 102 kg, with cross-sectional area of 100 cm^2, and the ambient pressure is 100 kPa. The pin is released, which allows the pis..

Water flows through a long tube of circular cross section : Water flows through a long tube of circular cross section at a mass flow rate of 0.01 kg/s. The heat flux through the wall is maintained uniformly at 3000 w/m^2. The water enters the tube at 20 C. The inside diameter is 7.5cm. Find the required lengt..

User Account

All Pages