Find the system transfer function of a causal lsi system

Assignment Help Electrical Engineering
Reference no: EM13249421

1) Find the z-transform x(z) of x(n) = cos(0.45n +0.25)u(n).

2) Find the system transfer function of a causal LSI system whose impulse response is given by

h[n] = (-0.5)^n-1 sin[0.5(n-2)]u[n-2] and express the result in positive powers of z. Hint: The transfer function is just the z-transform of impulse response. However, we must first convert the power of -0.5 from (n - 1) to (n - 2) by suitable algebraic manipulation.

3) Express the following signal, x(n), in a form such that z-transform tables can be applied directly. In other words, write it in a form such that the power of 0.25 is (n-1) and the argument of sin is also expressed with a (n-1) multiplier.

x[n] = (0.25)^n sin(pi/2 n) u [n-1]

 

4) The transfer function of a system is given below. Find its impulse response in n-domain. Hint: First expand using partial fraction expansion and then perform its inversion using z-transform tables

H(z) = 1/(z-0.5)(z+0.5)

 

5) The transfer function of a system is given by

H(z) = z/(z^2-0.8z+0.15)

Reference no: EM13249421

Questions Cloud

Describe hydrogen gas can be produced in the laboratory : Hydrogen gas can be produced in the laboratory through the reaction of magnesium metal with hydrochloric acid
At what rate is the top of the ladder sliding down the house : a ladder 61 ft. long is leaning against the side of a house. the base of the ladder is sliding away from the house at a rate of 6 ft/sec. At what rate is the top of the ladder sliding down the house when the base of the ladder is 11 ft. from the h..
Find the mass of the sculpture : A heavy piece of hanging sculpture is suspended by a 90 cm-long, 5.0 g steel wire. When the wind blows hard, What is the mass of the sculpture
Describe the market research process : Describe the market research process and then the notion of backward marketing research?
Find the system transfer function of a causal lsi system : Find the system transfer function of a causal LSI system whose impulse response is given byh[n] = (-0.5)^n-1 sin[0.5(n-2)]u[n-2] and express the result in positive powers of z. Hint: The transfer function is just the z-transform of impulse respon..
Explain oxygen gas react to form nitrogen dioxide : In the information of smog, nitrogen and oxygen gas react to form nitrogen dioxide. How many grams of NO2 will be produced when 2.0 L of nitrogen at 840 mmHg and 24 degrees C are completely reacted
What force does the floor exert on the block : A block weighing 15.0 N rests on the floor. What force does the floor exert on the block
Find the z-transform of functions by bringing into a form : Find the inverse z-transform, x(n), of the following functions by bringing them into a form such that you can look up the inverse z-transform from the tables. This will require some algebraic and /or trigonometric manipulation/calculation.
Define what happens to the atomic number of a nucleus : Explain what happens to the atomic number of a nucleus when positron emission occurs

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the total energy in joules expended during min interval

The power supplied by a certain source is a constant 7.5 W over the first 5.8 min, zero for the next 2.8 min, a value that increases linearly from zero to 10 W during the next 8.8 min, and a value that decreases linearly from 10 W to zero

  Estimate of how to divide the amount of the project goal

the project manager on a development project working on a new line of laptop computers. The project has been broken down into the following modules: Power supply, Processor and motherboard with RAM, I/O circuit board

  Find the magnetic field produced by the two filaments

Two strands of infinitely long current rights carry currents of equal magnitude. Find the magnetic field produced by the two filaments at the midpoint between the two strands. Compare this result if the currents: a) have the same direction

  Create a bandpass filter with cutoff frequencies

Create a bandpass filter with cutoff frequencies of 100-1k, attenuate by at least 3db at desired frequency(100-1k) and at 60Hz attenuate by 10 db. Resistor, Capacitor, Inductor, and Op-amps can be used.

  Develop the voltage loop equation in terms of current

A lossy resonator consisting of a series connected RLC circuit is attached to a voltage source Vs=Vo(e^(jpi/3)) a) Develop the voltage loop equation in terms of current i(t), R, L, C, and vs b) Find the corresponding phasor equation

  Create a program using asmide

Create a program using AsmIDE, which utilizes the Fox 11 68HC11 microcontroller board: Speech timer where max time is 5 minutes Use the switches for:

  Find the normalized voltage magnitude values at the load

You are to specifically find the normalized voltage magnitude values at the load plane and the voltage maxima and minima points on the line and 9 additional points which are spaced at intervals of 0.05 ohm from the load plane, i.e., at a total of ..

  Explain difference between hard and soft-decision decoding

Explain the difference between hard-decision and soft-decision decoding in partial response signaling, including the relative advantages and disadvantages of each.

  Binary number operation

Using 4-bit numbers to save space, multiply 3ten  x 4ten in binary.

  What makes base 16 an attractive numbering system

1.Convert 5EDA into binary number. What makes base 16 (Hexadecimal) an attractive numbering systems for representing values in computers 2. What is 4365 - 3412 when these values represent unsigned 12-bit octal numbers

  Find an expression for half-life of voltage in terms r and c

We use the time constant to characterize transients in electric circuits. In physics, the half-life is often used to characterize the exponential decay of physical quantities such as radioactive substances.

  Determine what is the cost per ic

A semiconductor company has the following costs associated with Product X: - Fixed cost of $1B ($1,000,000,000) - Die cost of $6 at a die yield of 50% - Testing and packaging cost of $3 per die - A final test yield of 90% with a product volume of 500..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd