Find the speed of the sphere after the acceleration

Assignment Help Electrical Engineering
Reference no: EM13228148

a small sphere has a mass m=10^-3 kg and charge q =+1.00uc. The charge is release from rest and accelerate through a potential difference of 100000v. (a) Find the speed of the sphere after the acceleration. (b) if the sphere (which is already up to its max)is fired directly at a fixed (can't move) charge q=+2exp-5C. how close do the two charrges get before the first charge stops and reverses direction.

Reference no: EM13228148

Questions Cloud

Explain a different substitution reaction that should yield : None of the desired ether was obtained. What product was formed and why did this route to the ether fail? Suggest a different substitution reaction that should yield the desired product.
Write formula for the magnetization volume current density : Write the formula for the magnetization volume current density J M and magnetization surface current density JMS in terms of magnetization vector M. 4. A sphere has permanent magnetization where is a positive constant.
State what is its molar mass : A sample of a gas weighs 2.006 g and has a volume of 1060.0 mL at 795.0 torr and 32.0 degrees Celsius. What is its molar mass?
State what is the partial pressure of co : A mixture of 0.146 moles of C is reacted with 0.117 moles of O2 in a sealed, 10.0L vessel at 500 K, producing a mixture of CO and CO2. The total pressure is 0.640 atm. What is the partial pressure of CO?
Find the speed of the sphere after the acceleration : The charge is release from rest and accelerate through a potential difference of 100000v. (a) Find the speed of the sphere after the acceleration. (b) if the sphere (which is already up to its max)is fired directly at a fixed (can't move) charge q..
What is the binary value on the a-d output pins : An 8-bit A/D converter has Vref- = 2 V and Vref+ = 5 V. The analog input signal vin has a frequency range of 300 Hz to 3.4 kHz. a) If vin = 7 V, what is the binary value on the A/D output pins b) If vin = 1 V, what is the binary value on the A/D outp..
What might be an example of an input and an output : (1) What might be an example of an input and an output What are some simple examples of what constitutes the distinction between input into a program and output from the program (2) What type of arithmetic operations are supported in C++
Explain concentration is required to precipitate : If the concentration of Mg2+ ion in seawater is 1350 mg/L, what OH- concentration is required to precipitate Mg(OH)2
Compute the concentrations of the nonionized acid : Calculate the concentrations of the nonionized acid (HA) and of the ions of a 0.100 M formic acid (HCO2H) solution at equilibrium, and calculate % ionization.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What should thevenin equivalent resistance of power amplier

Suppose you are designing a power amplifier for a loudspeaker which has an equivalent resistance of 150 . What should be the Thevenin equivalent resistance of the power amplifier in order to maximize the power transfer to the loudspeaker

  Explain what is the conductance of two parallel conductors

What is the relation between the conductance and the capacitance of two parallel conductors immersed in a lossy dielectric medium that has permittivity and conductivity?

  Rate at which succesful packets arrive at network node

Rate at which succesful packets arrive at network node, After traversing a wireless filled channel packets arrive at a networks node according to a Poisson process with rate Lambda

  Ziegler-nichols open loop tuning

Ziegler-Nichols Open Loop Tuning Often, when working with a faster loop, many people will opt only for a PI control philosophy

  Determine an equation for angular velocity

If the battery is replaced with a 6 Volt battery it was experimentally determine that the no load speed is reduced to 120 rpm. For this situation, determine a new equation for angular velocity,(in rad/sec) versus Torque (in Nm).

  Determine the battery voltage required to obtain a flux

the magnetic circuit shown with a mean core length of 52 cm and a cross sectional area of 18 cm^2. the length of the air gap is 0.14 cm. Determine the battery voltage required to obtain a flux density of 1.2 T in the air gap. Use the magnetization..

  Explain wavelength and frequency the downstream information

Wavelength and Frequency, The downstream information (from the network to the customer) is transmitted at a wavelength of 1550 nanometers and the upstream information

  What is the sample period ts

What is the sample period Ts?

  Explain what is the impedance of the load

A load has a 20 ohm resistor and a 4 Henry inductor connected in series. It is connected to a power source with v(t) = 100 cos(50t), connected in series to the load. What is the impedance of the load? Use phasor transform methods to obtain your an..

  Compute the fourier coefficients for the harmonics

Compute the power levels of the 2nd, 3rd, and 4th harmonics relative to the fundamental output signal for the Class C amplifier. compute the Fourier coefficients for the harmonics of the clipped sinusoid that results from the partial conduction an..

  Explain the physical meaning of z transform

Please list the properties of Discrete Fourier Transform. Explain each property with an example to show what it means physically and explain the physical meaning of Z Transform

  How much hydrogen would be needed

How much hydrogen would be needed to give the car a range of 300 miles if the source of electricity is an on-board fuel cell with an efficiency that is 50% of the ideal?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd