Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A partially full can of soft drink is placed at the outer edge of a child's merry-go-round, located R = 1.5 m from the axis of rotation. The can diameter and height are D = 65 mm and H = 120 mm. The can is half-full of soda, with specific gravity SG = 1.06. Assume rigid body motion.
A. Find the slope of the liquid surface in the can if the merry-go-round spins at 0.3 revolution per second.
B. Find the spin rate at which the can would spill, assuming no slippage between the can bottom and the merry-go-round.
the unit cell for uranium has orthorhombic symmetry, with a, b and c lattice parameters of 0.286, 0.587 and 0.495nm, respectively. if its density, atomic weight, and atomic radius are 19.05g/cm3, 238.03g/mol and 0.1385 nm respectively, compute the..
How can be determined the dynamic parameters of a second order system, wiht an Inertia (M), a dampening coeficient ( C ) and a Stiffness constant ( K).
Determine the power of the pump. The efficiency of the pump is 65%.
An Industrial water shutoff valve is designed to operate with 40lbs of force and will encounter 150lbs of resistance force applied to a 2in diameter axle. What is the required actual mechanical advantage of the system?
Determine the heat transfer coefficient for laminar flow over this cylinder. First, at your discretion, select an available set of experimentally obtained data from the literature. Then, this would provide you with a set of Reynolds numbers.
Determine the natural frequencies of the system. For the baseline system I get natural frequencies at the following engine speeds: 435, 2026, 2818, 5225, 7093, 10245, and 12153 rpm.
a large tower is to be supported by a series of steel wires.it is estimated that the load on each wire will be 11100N. determine the minimum required wire diameter assuming a factor of safety of 2 and a yield strength of 1030MPa.
A Pitot-static probe connected to a water manometer is used to measure the velocity of air. If the de?ection (thevertical distance between the ?uid levels in the two arms) is 7.3 cm, determine the air velocity. Take the density of air to be 1.25 k..
Calculating electrical power from a geothermal Resource, A geothermal well is producing 9000kg/second from a hot water basin at 200 ºC [enthalpy of 800 KJ/Kg].
Using the formula to compute torque and having a torque of 4966.97, with the RPM's at 250, Would my calculation for horsepower be correct at 236.4 hp?
In order to increase production rate a reactor set point was increased from 160 psig to190 psig. The reactor pressure transmitter was recalibrated from 0-200 psig to 0-300 psig.
Determine the minimum distance from a 50 ft height building from which the ball can be thrown and not hit the side of the building , but it may land on the roof depending upon how long the building is.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd