User Account

All Pages

Find the reflection coefficient

Assignment Help Electrical Engineering
Reference no: EM131202745

A 100 m-long RG 58 coax cable is terminated with 150 Ω impedance.

(a) Find the reflection coefficient.

(b) If a very short, 10 V pulse is launched at the input, calculate the time it will take for the pulse to return to the input and voltage be.

Reference no: EM131202745

Questions Cloud

Determine the signalto-noise ratio : This signal exists in background noise which has a level of 5 mV rms. Determine the signalto-noise ratio and the information rate of the digitized signal.
Explain each part of the key components : Explain each part of the key components. Explain each part of contributing factors. Provide examples of ways to measure each part.
Determine the rate of the resulting bit stream : In the design of a PCM system, an analog signal for which the highest frequency is 10 kHz is to be digitized and encoded with 6 bits. Determine the rate of the resulting bit stream and the signal-to-noise ratio.
Explain a substantial amount of the variation in salaries : MBQC 862 - Business Decision Modelling Explain a substantial amount of the variation in salaries among these managers - What is your best estimate of the systematic difference between male and female salaries?
Find the reflection coefficient : If a very short, 10 V pulse is launched at the input, calculate the time it will take for the pulse to return to the input and voltage be.
Discuss the benefits of a forensic readiness plan : Discuss the benefits of a forensic readiness plan and name what you believe are the top 3 requirements to establish forensic readiness within a private sector business.
Determine the bandwidth required for a data rate of 10 mbps : Determine the bandwidth required for a data rate of 10 Mbps. Assume simple pulses, equally spaced, such as in the square wave shown in Fig. 9.12, to represent the information bits.
What can wanda do to try to ensure edith cooperation : Should Wanda perform the test? Explain your answer. How can Wanda emphasize the importance of following the diet, fasting, and test instructions?
Find the percentage of power traveling : A 300 Ω transmission line is connected directly to the 50 Ω input of a television set. Find the percentage of power traveling on the transmission line that is available to the TV set.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the effect on ia and speed if the load torque double

A shunt-connected a DC motor has zero rotational losses and RA = 0. Assume that RA and Radj is constant [except in part (d)] and that φ is directly proportion to field current. For VT= 200 V and Pout = 2 hp.

  Explain telephone channels and pcm analysis

Telephone channels and PCM analysis, The analog to digital converter (ADC) used in a telephone system outputs 8 bit words. The digital words are transmitted as a serial stream to form a PCM voice signal

  What form of linear distortion is introduced by the channel

Phase distortion - the phase response is not linear with frequency inside the frequency band of interest. Different frequency components are subject to different delay in passing through the system.

  What is probability that there will be more than 100 calls

The arrival rate of calls at a mobile switiching station is 1 per second. The probability of k calls in a T second interval is giving by poisson PMF with h=arivial rate x T. What is the probability that there will be more than 100 calls placed in ..

  What is the time constant for discharging the capacitor

The light from a cameras electronic flash is produced when a high voltage obtained by charging a capacitor is applied to electrodesin a xenon-filled flash bulb. (a) to what voltage would a 60-microfarad capacitor be charged by a6mA current lasting ..

  Draw a state diagram and check for redundancies

A synchronous sequential machine is to have a single input line and a single output line. Draw a State Diagram (Mealy) and check for redundancies and Then assign binary State Identifiers

  What is the positive frequency in hz of the null bandwidth

The discrete-time signal x[n] is actually the result of sampling a periodic continuous signal x(t). The signal x[n] is 1 from -12 to +12, zero from n = 13 to 87 and then it repeats. What is the positive frequency (in hz) of the Null Bandwidth

  How do circuits work

How do circuits work?- explain and show a diagram.

  Design a second-order banpass filter with center frequency

Design a second-order banpass filter with center frequency f=10. The gain should be zero at t=0 and t= 8. Select poles at -a ±j10.  Explain the influence of a on the frequency response.

  Implement the equation if a power amplifier is available

A 4 to 20mA control signal is loaded by a 100Ohm resistor and must produce a 20 to 40V motor drive signal. Develop the equation relating the input current to the output voltage.

  Calulate the number of scrs in series and parallel units

A number of SCRs, each with a rating of 2000V and 50A are to beused in series-parallel combination in a circuit to handle 11KV and400A. For a derating factor of 0.15, calulate the number of SCRs in series and parallel units.

  Derive the state diagram for fsm that has input and output

Derive the state diagram for an FSM that has an input w and an output z. The machine has to generate z = 1 when the previous four values of w were 1001 or 1111; otherwise, z = 0. Overlapping input patterns are allowed.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd