Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The maximum radar cross section of a resonant linear λ / 2 dipole is approximately 0.86λ2 . For a monostatic system (i.e., transmitter and receiver at the same location), find the received power (in W) if the transmitted power is 100 W, the distance of the dipole from the transmitting and receiving antennas is 100 m, the gain of the transmitting and receiving antennas is 15 dB each, and the frequency of operation is 3 GHz. Assume a polarization loss factor is -1 dB.
What is the minimum detection distance, if the radar's sensitivity is 1 nW?
Explain the process of processor development
Design (showing address, data, control line connections) a 32*8 low-order interleaved memory system using 16*2 memory chips for a system that uses 8-bit address bus.design assuming the unused address lines to be all ‘0's
the circuit has been connected for several seconds, find current in (a). in the 4.00 volts battery, (b). in the 3.00 ohm resistor, (c). in the 8.00 volts battery, (d). in the 3.00 volts battery and (e). find the charge on the capacitor?
A ball is dropped from a height of 10 feet. Each time it strikes the ground, it bounces up to 80% of the previous height a.What height will the ball bounce to after it strikes the ground for the third time b.How high will it bounce after it strikes ..
We will make the follwoing probability assumptions: When team A plays team B, the probability that team A wins is given by: P(A wins) = \(([seed(B)+3]^2)/([seed(A)+3]^2 +[seed(B)+3]^2) \)
An LVDT with associated signal conditioning will be used to measure work-piece motion from -20 to +20 cm. The static transfer function is 2.5 mV/mm. The output will be interfaced to a computer via an ADC.
The current through a branch in a linear network is 2 A when the input source is 10 V. If the voltage is reduced to 1 V and the polarity is reversed, the current through the branch is a. - 2 A b. - 0.2 A c. 0.2 A d. Cannot be determined with the in..
Discuss the procedure for design using anthropometric data. Include Confidence Intervals (CIs). Select any one anthropometric measurement for males or females in Table 5.3 and find 90% CI for the mean measurement of the population.
Find the minimal sum and distinguished 1-cell using Karnaugh Maps for the following functions, also state essential prime implicants (if any) and which are non-essential prime implicants (if any) a. F = fA,B,C,D (2,,4,6,7,12,13,14,15)
A silicon (ni= 10^10 cm^-3) p-n junction diode has a maximum electric field of -10^6 V/cm and a depletion layer width of 1 um. The acceptor density in the p-type region is four times larger than the donor density in the n-type region.
An LC circuit consists of a capacitor, C = 3.16 ?F, and an inductor, L = 5.80 mH. The capacitor is fully charged using a battery and then connected to the inductor. An oscilloscope is used to measure the frequency of the oscillations in the circui..
When electros and holes are present in a semi-conductor, the presence of an electric field produced by an external voltage will cause this carries,which have changes of oposite sign, to move in opposite directions.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd