Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
he real power delivered by a source to two impedances, Z1=3+j4 ohm and Z2=10 ohm, connected in parallel, is 1100 W. Determine (a) the real power absorbed by each of the impedances and (b) the source current.
The nickel- cadmium (nicad) battery is a secondary battery, meaning it can be recharged. it has the following reactions occuring during discharge: A nicad battery has .87 g of cadmium, which is the limiting reactant.
Let f(a,b) = b' + a. (a) Derive the truth table for f. (b) What is the canonical sum-of-products expression for f? Do not use the shorthand notation. (c) Prove by Boolean algebra that the original expression is the same as the canonical SOP expres..
A 1 kHz sine wave signal with a power level -10 dBm is applied to the input of the amplifier. What is the power at the amplifier output in dBW?
Design a simple unipolar drive circuit such that the electrical time constant is 2 msec at phase turn-on and 1 msec at turnoff. The stepping rate is 300 steps per second. A three-phase variable-reluctance stepper motor has parameters.
Discretization - How does the size of the differential charge elements influence your results Find E at the point (0, a/2, a), for this study. Devise a good way to represent your data to demonstrate the influence of discretization.
If each gold atom donates one electron to the gold matrix at room temperature, estimate the electron concentration of gold. Is gold a conductor?
What is the effect of a frequency difference between the carrier and local oscillator on output quality? Show mathematically.
The charge is release from rest and accelerate through a potential difference of 100000v. (a) Find the speed of the sphere after the acceleration. (b) if the sphere (which is already up to its max)is fired directly at a fixed (can't move) charge q..
A 150 MVA, 24 kV, 123% three-phase synchronous generator supplies a large network. The network voltage is 27 kV. The generator operates with an induced voltage, which is twice the rated line-to-neutral voltage.
Built-in voltage for a Si p-n junction is tested to be 0.6 V, NA = 2 X 10^15 cm^-3 on p side. Find ND on n side. (Assume ni = 1 x 10^10 cm^-3; and k*T/q= 0.026 V)
The bellows, diaphragm, and Bourdon tube pressure sensors all exhibit second order time response. This means that a sudden change in pressure will cause an oscillation in the displacement and, therefore in the sensor output.
Calculate the signal to noise ratio given RMS Noise Voltage = 20mV and RMS Signal Voltage = 2.5V Calculate ETotalRMS given e21RMS = 5V and e22RMS = 7V
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd