Find the power crossing into a given transverse plane

Assignment Help Electrical Engineering
Reference no: EM13230526

a parallel plate transmission line is made up of perfect conductors of width w = .2m and d = .01m. The medium between the plates is a diaelectric of epsilon = 2.25*(epsilon not) and mu = mu not. For a uniform plane wave propagating down the line, find the power crossing into a given transverse plane for each of the following.

a) the electric field between the plates is 300piV/m.

b.) the magnetic field between the plates is 7.5A/m.

c.) the Voltage across the plates is 4*pi V.

d.) the current along the plates is .5A.

Reference no: EM13230526

Questions Cloud

Define what is the molarity of the solution : In the laboratory you dissolve 16.7 g of barium chloride in a volumetric flask and add water to a total volume of 125 mL. What is the molarity of the solution
What do kleinfelds efforts at siemens tell you about : What do Kleinfelds efforts at Siemens tell you about the difficulties of restructuring organizations?
State responsibility and environmental regulation : State Responsibility and Environmental Regulation - Are there any objections to the ICJ's jurisdiction that State Z may be able to raise
Evaluate the skills necessary in conducting change processes : Evaluate the skills necessary in conducting change processes within an organization.
Find the power crossing into a given transverse plane : a parallel plate transmission line is made up of perfect conductors of width w = .2m and d = .01m. The medium between the plates is a diaelectric of epsilon = 2.25*(epsilon not) and mu = mu not. For a uniform plane wave propagating down the line
International and comparative law : International treaties that have been ratified by the Australian government do not as such form part of our domestic law or operate as a direct source of individual rights and obligations under that law.
What is value of the electric field perpendicular to surface : If an electric field in free space of 57.1 V/m makes an angle of 41 degrees to the surface normal of a dielectric slab with relative permittivity 4.01, what is the value of the electric field perpendicular to the surface just inside the slab
Compute the ph volumes of acid : A 20.00-mL sample of 0.150 M KOH is titrated with 0.125 M HCIO4 solution. Calculate the pH after the following volumes of acid have been added.
Find vc in terms of the arbitrary constants c1 and c2 : Consider an RLC circuit with R = 5 Ohms, L= ½ H, C= 2/9 F and input voltage e(t) = exp(-t/2)a. Starting from KVL show that the DE for the voltage across R is given by: v'' + 10 v' + 9 v = -5 exp(-0.5 t) b. Find vc in terms of the arbitrary constants ..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain deploy a wireless telephone system

You have a bandwidth of 10 MHz (per direction) in a single-cell system and want to deploy a wireless telephone system. You have the following options: analog 30-kHz channels (as in AMPS)

  What approximate minimum ber is required for voice signals

What approximate minimum BER is required for voice signals, data signals and what is the approximate BER level for the optical fiber systems ?

  Determine the current in the neutral wire

A three-phase, wye-connected induction motor is supplied by a three-phase and foursin system with line-to-line voltage of 220V and the impedance of the motor is 6.3+j3.05Ohm per phase.

  What is the period and spectrum of the signal

Consider the signal x (t) = 10+ 20 cos (100*2 t + 4) + 10 cos (250*2 t ) A. Using Euler's relation, the signal x(t) defined by the above equation can be expressed as a sum of complex exponentials in the form X(t) = x0 + Re{k=1N Xkejk2fot}

  Calculate the percent increase is attenuation

Rayleigh Scattering. Calculate the % increase is attenuation due to Rayleigh scattering exhibited by light having a free-space wavelength 1535 nm as compared to light having a free space wavelength 1550 nm. Provide your answer in units of [%] and ..

  Determine the corresponding time-domain signal sr

The sampled signal is passed through an ideal LPF which rejects all frequencies above 8 kHz and has a gain Ts. Les sR(t) be the output of the LPF. Sketch LT[sR(t)], in which FT[] denotes the Fourier Transform, in frequency domain.

  Select the amplitude a to produce an average power

The message signal x(t), in the following system has a nabdwidth of 10kHz. The center frequecy of the Narrow Band Frequency Modulated (NBFM) signal nbfm(f) is 1Mhz, the frequency deviation f1=1khz and the amplitude of the NBFM signal is 1V.

  Estimate of the maximum fundamental operating frequency

Using the LM555 data sheet, make an estimate of the maximum fundamental operating frequency in the astable mode.

  Future generation telecommunication technology

Write a report on Future Generation Telecommunication Technology.

  Calculate the mmf when the machine operates

calculate the mmf when the machine operates at rated voltage at full load? PLease explain how to get the solution to this problem?

  What is the maximum effective data rate of the link

Consider a satellite communication link with a one way propagation delay of 300ms between the sender and receiver, operating at 10Mbps using packets of length 1500bytes. Length of the ACK packet is also 1500 bytes.

  Find the complex power of the other load

two loads connected in parallel are supplied from a single phase 240v rms source. the two loads draw a total real power of 400 kw at a power factor of 0.8 lagging. one of the loads draws 120 kw at a power factor of 0.96 leading.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd