User Account

All Pages

Find the power absorbed by the machine

Assignment Help Electrical Engineering
Reference no: EM131201097

Two-wattmeter method is used to measure the power absorbed by a 3-phase induction motor. The wattmeter readings are 12.5kw and 4.8 kw.

find:

i) the power absorbed by the machine

ii) load power factor

iii) reactive power taken by the load.

Reference no: EM131201097

Questions Cloud

Specialization of labor and growth in wage rates : How have increases in the unemployment rate impacted the specialization of labor and growth in wage rates?
Discuss advantages of learning centers in an early childhood : Discuss 2 advantages and 2 disadvantages of learning centers in an early childhood classroom. Share what centers you would implement in your classroom and determine why you chose them.
Calculate power factor of the motor at no load : Two-wattmeter method is used to measure the power taken by a 3-phase induction motor on no load.- Calculate power factor of the motor at no load.
Determine the shear stress in the pin at a : The horizontal beam is supported by a pin at C and a rod attached to point A.
Find the power absorbed by the machine : Two-wattmeter method is used to measure the power absorbed by a 3-phase induction motor.- Find the power absorbed by the machine. - Find load power factor.
What percentage of reported rape cases do police make arrest : Shield laws protect women from being questioned about their __________ unless such questioning bears on the current rape case. What percentage of reported rape cases do police make an arrest?
Discuss the various impacts that technology has had : Discuss the various impacts that technology has had on the healthcare environment and some of the opportunities as well as challenges they may provide.
The peak correction value used in the measurements system : Show a flowsheet program that represents the peak correction value used in the measurements system.- Use block diagram.
Describe an example of a diverse need : Select 3 of the 10 procedures described that may need to be adapted to students who have diverse needs. Describe an example of a diverse need that would warrant an adaptation and how the procedure could be adapted.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the full-load current in each winding

The magnetic flux density in the core of a 4.4-kVA, 4400/440-V, 50-Hz, step-down transformer is 0.8 T (RMS). If the induced EMF per turn is 10 V

  Calculate the maximum amount of charge

Maximum charge on the globe. Calculate the maximum amount of charge that can be placed on the globe without causing breakdown in air. Assume a radius of 6400 km and breakdown occurs at 3 x 106 V/m.

  Determine how many atoms per unit cell does it have

Polonium (Po) is the only material which forms a simple cubic crystal (i.e., it is not FCC or BCC) structure with atoms at the corner positions. It is a metal (but it is radioactive so it has very few engineering applications!). Its atomic number ..

  Writing a report about the expriment meter circuits

Writing a report about the expriment meter circuits. Your report should include A discussion of the technique for measuring the meter internal resistance.

  Find the noise figure of the overall system

An amplifier with a gain of 12 dB, a bandwidth of 150 MHz, and a noise figure of 4 dB feeds a receiver with a noise temperature of 900 K.

  Determine the dbm level for an output of 120mw

Determine the dBm level for an output of 120mW A power level of 100W is 6dB above what power level Find the output voltage of an amlifier if the applied voltage is 20mV and a dBv gain of 22 dB is attained

  Calculate the land area covered with photovolatic cells

Assume the average energy density of sunlight to be 800 w/m^2 ---and the overall photovolatic system efficiency to be 10 percent. Calculate the land area covered with photovolatic cells needed to produce 1000 Mw , the size of a typical large centr..

  Show a timing diagram

Use Active HDL to show a timing diagram showing the inputs, outputs, and state (including last A) of the VHDL state machine of the attached design and bench test

  Give state description of system use state vector approach

The output is 1 when the pattern abca has occurred an even number of times in x(0,t). Give a state description of the system. Use a state vector approach and a minimum-number-of-states approach.

  Find the string efficiency if a guard ring increases

The shunt capacitance of metal work ofeach insulator is 0.26C to earth and 0.15C to line. Find the stringefficiency if a guard ring increases the shunt capacitance to lineof the metal work of the lowest insulator to 0.35C.

  50 or 60 hz frequency transformer

When operates on 50 or 60 Hz frequency transformer, Which one will give more Output?

  Define cellular operator designs a network reuse pattern

TDMA has 416 frequencies in one of the cellular license bands. If a cellular operator designs a network with a 5/15 reuse pattern, how many frequencies per cell (sector) can be supported? ( ignore control channels)

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd