Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An Al0.3Ga0.7As p-n junction LED with doping level ND = 1 x 10^18 cm-3 on n-side and NA=1x10^15 cm-3 on p-side has Vf = 0.9 V forward bias across its junction. The LED cross-section is 200 µm x 200 µm. Electron/hole radiative and non-radiative lifetimes are 20 ns and 180 ns correspondingly; diffusion coefficient of electron is 155.4 cm^2/s and ni = 5 x 10^6 cm-3.Find the LED current
consider an ideal amplifire with inverse feedback. explain what is meant by a virtual ground for both inverting and non-inverting connections
There are three numbers stored in Memory Locations 10-12. Write a machine language program to load each number in the accumulator one at a time. Use the immediate addressing mode to add four to each value that is loaded to accumulator.
A DSP system has a sampling frequency of 800 HZ. What is the maximum frequency of the analog signal so that the aliasing would not occur
A Bandpass Filter, made up of a High pass RC circuit to a Low Pass RC circuit has values of R1=R2=10.0 kohm and C1=C2=0.01uF is created. Varying the driving frequency from 10Hz to 1MHz in decades and measure Vout and the phase angle.
The output/ input of a system is 30dB. detrmine the ratio Express x(t)=4*cos(100*t-45)+ 2*cos(250*t+30) in terms of exponential functions Then Detrmine the phase angles(in degrees) of the two frequency components of x(t).
A 500-kVA, 60Hz, 5000V, Y-connected, 10 pole synchronous has internal parameters of Armature Resistance 1ohm amd Synchronous Reactance 10ohms. The generator is operating at rated values and 0.9 pf leading.
If this op amp is used in a non-inverting amplifier having a closed loop dc gain of 100, sketch the bode plot of the magnitude of the closed loop gain to scale. Repeat for a closed-loop dc gain of 10.
Bode plots were introduced in my second circuit analysis class, but I really didn't think it was important because it looked like an outdated tool no longer in use.
It the resistors used are not ideal but have a ±5% manufacturing tolerance, what are the extreme output voltage and resistances that can result?
Determine the value of the constant c such that the following functions are valid probability functions: A. p(x) = cx/20, x = 1,2,3,4,5,6 and zero elswhere. B. p(x) = c(X^2 + 1), x = 1,2,3,4,5, and zero elsewhere.
Through the data sheet the power meter is 4.5 HP. Find the hp range for PH-3A-HG in hp. The power meter measures the power and outputs a 0 - 10 voltage signal. Calculate the conversion factor for converting the voltage output
A coaxial cable connects a 50W transmitter to an antenna with a feed impedance of 200W. The operating frequency is 900MHz and the cable has a velocity factor of 0.66. Determine the characteristic impedance and length of the cable.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd