### Find the minimum-cost sop expression for the function

Assignment Help Electrical Engineering
##### Reference no: EM13254835

1. Find the minimum-cost SOP expression for the function F1 = fm(0,2,4,6,8,10,14) + d(1,5,11,15) using K-Maps. Model the function F1 using (a) Dataflow Modeling, (b) Behavioral Modeling, and (c) Structural Modeling. Use Modelsim and a VHDL test bench to simulate all the three models.

2. Model and simulate a 4-to-1 multiplexer using (a) Dataflow Modeling, (b) Behavioral Modeling, and (c) Structural Modeling. Use Modelsim and a VHDL test bench to simulate all the three models for a 4-to-1 multiplexer. Use basic gates for structural modeling.

### Write a Review

#### What are the consequences with regard to fc

A given low pass filter has a cutoff frequency fc and a sample frequency fs. The sampling period is T = 1/fs. In implementing the filter it is essential that the evaluation of the difference equation be completed in less.

#### Amplify the signal of a microphone with internal resiatance

What value of emitter resistor would you choose, if: a) You have to amplify the signal of a microphone that has an internal resistance of 100K using a Common Emitter bias configuration b) you have to drive a load of 50 with an Emitter Follower cir..

#### Write a testbench stimulus

Write a testbench stimulus for the below 8-bit Shift-Left Register with Positive-Edge Clock, Serial In and Serial Out. Start with all ones after the 8th=bit shifted to the left all zeros.

#### Find the thevenin resistance between terminals

Assuming the op amp is not saturated, find the Thevenin resistance between terminals (a,b). Since there is no independent voltage or current supply, the Thevenin voltage is zero, and one must attach a test source at (a,b)

#### Find what would be the terminal voltage of the battery

When disconnected and fully charged, the voltage across the battery terminals is measured to be 13.8 V. When connected to a load that dissipates 18 W of power, the terminal voltage of the battery decreases to 12 V.

#### Implement a multiple mode counter

Implement a multiple mode counter

#### Give relationship of ideal gas btwn pressure and temperature

create a graph showing the relationship of an ideal gas between pressure (P) and temperature (T). The ideal gas law relates the pressure, volume, amount, and temperature of an ideal gas using the relationship: PV = nRT.

#### What is the combined gain-loss of the two cascaded blocks

An amplifier has a gain of 10 and follow a bandpass filter filter where the loss in the in the center of the bandpass is 0.05. What is the combined gain/loss of the two cascaded blocks at the center frequency of the filter

#### Explain when the bowling ball is placed on the spring

A bowling ball is placed on a coil spring. The spring constant is 400N/m. When the bowling ball is placed on the spring, the spring compresses down 0.1m. If the spring is vertical how far will the bowling ball go

#### Determine free electron and hole concentration

(a) Determine free electron and hole concentration.(b) Calculate the effective density of states at valence band, Nv. Given that ni = 1x1010 cm3 and kT = 0.026.

#### What does the shift register contain after three clock pulse

A byte containing 01100011 is right shifted (right-most bit first) into an 8-bit shift register with an initial state of 00110110 (01100011=>00110110) What does the shift register contain after three clock pulses

#### Explain what is the shape of the spectrum of the signal

What is the shape of the spectrum of the signal? What is the extent of the spectrum in the frequency domain? What is the unit that is applied to the magnitude of the spectrum?