Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Ball bearings of plain carbon steel are to be hardened by quenching them in a water bath at a temperature of 37oC. You are asked to devise a continuous process in which the ball could roll from a soaking oven at a uniform temperature of 870oC into the water, where a rubber conveyor belt carries them away. The rubber conveyor belt, however, would not be satisfactory if the surface temperature of the balls leaving the water is above 90oC. If the convective coefficient is equal to 590 W/m2.K, (a) find the minimum allowable cooling time in the water for balls up to 1.0 cm in diameter, (b) calculate the total amount of heat to be removed from the water bath in order to maintain a uniform temperature if 100,000 balls are to be quenched per hour.
12 lbm of superheated water vapor at 60psia and 500deg c in a piston cylinder device is cooled at constant pressure
the fluid used is r-134a. the flow of r-134a is 70 lbmmin. if r-134a enters a compressor at -10 deg f and is a
although the hume-rothery rules apply strictly only to metals the concept of similarity of cations corresponds to the
The flow around a model of a turbine blade is investigated. The model is five times larger than the prototype. A maximum pressure of 4 psi is measured at the leading edge, a maximum velocity of fps is measured near the top of the blade, and a small d..
The rack structure will be built 2 ft above floor level, and the clearance between the rack structure and the ceiling of the building must be at least 18 in. Determine the dimensions (height, length, and width) of the rack structure.
combustion products with the molar anaylisis of 10 co2 20 h2o 70 n2 enter an engines exhaust pipe at 1000f 1atm and are
a thick cylinder has an inside diameter of 60 mm and an outside diameter of 100 mm. it is pressurised internally until
What is the nature of the process fluid and what are the objectives of the two sample points and in what way do the samples reaching the instruments differ?
an ogee spillway of a gravity dam is to be modeled using water. the spillway section is 40 feet high its crest length
Knowing that the gage pressure inside the tank is 5 MPa, determine the maximum stress and the maximum shearing stress at point L.
a feeder heater extracts steam from a turbine at 600kpa and 250c which it combines with 0.3 kgs of liquid at 600 kpa
a jet engine propels an aircraft at 300 ms through air at 60 kpa and 0 c. the inlet diameter of this engine is 2 m the
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd