Find the mass flow rate that can generate 85 mw of power

Assignment Help Mechanical Engineering

Reference no: EM13619071

Design a stationary steam power plant operating on an ideal closed loop Rankine cycle that can deliver 85 MW of net power. The power plant is to be located at a site near a lake where the annual average temperature is 23 °C.

(1) Draw a diagram of the system, and state necessary assumptions. Specify inlet and outlet states for the pump, boiler, turbine and condenser.

(2) Select the maximum allowable temperature in the system and appropriate pressure range based on realistic constraints such as economic, environmental, social, political, ethical, health and safety, manufacturability, and sustainability, etc. You must justify your selection based on the constraints.

b) Find the mass flow rate that can generate 85 MW of power and determine the thermal efficiency of your system

(c) The condenser is cooled by running the cooling water from a nearby lake through the tubes of the condenser. If the temperature increase of the cooling water cannot be over 12 °C, what is the minimum mass flow rate of cooling water?

(d) The efficiency of the power plant can be improved by decreasing the condenser pressure. Select an appropriate condenser pressure lower than used in item for your Rankine cycle, and show the percent increase in efficiency.

(3) The efficiency of the power plant can also be improved by using a reheat cycle. For the reheat cycle select the same condenser pressure as in item 2, and the same exit temperature of reheater as the maximum temperature that you used in item (2), then, select an appropriate reheat pressure. Show the effects of reheat on the efficiency by comparing it with the efficiency of the basic Rankine cycle that you obtained in 2b and determine

(a) Percent increase in efficiency due to reheating, (b) Mass flow rate of the steam, (c) Mass flow rate of cooling water,

(d) For the same reheat cycle, select a higher reheat pressure than used in item (3) keeping all the other parameters same. Recalculate the quality at the turbine outlet to show that increasing the reheat pressure decreases the quality at the turbine exit.

(4) Discuss how you can further improve the efficiency of the power plant with realistic constraints stated in item (2).

Reference no: EM13619071

Questions Cloud

What is the electric field strength at the midpoint between : two 2.0-cm-diameter insulating spheres have a 6.70cmspace between them. one sphere is charged to 83.0nc the other to -

If the population standard deviation is 123 bushels per : the state department of agriculture is trying to determine the average corn yield for farmers in the state. they take a

Draw mohrs circle for a point on top of the cross-section : a simply supported beam of length 18 ft. is subjected to a trapezoidally distributed load that has a value of 3 kipft

The temperature of the parallel surfaces at the both ends : consider a 1-cm-diameter and 0.3-m-long copper rod kcopper 400 wm-k with its ends fixed to two parallel surfaces. the

Find the mass flow rate that can generate 85 mw of power : design a stationary steam power plant operating on an ideal closed loop rankine cycle that can deliver 85 mw of net

Calculate a the power required by the compressor in kw b : he vapor compression heat pump operates at steady state using refrigerant 22 whose flow rate is 6kgmin. the heat pump

A heat engine absorbes 25 mw from a 400 c combustion : a heat engine absorbes 25 mw from a 400 c combustion chamber and rejects 15 mw to the atmosphere at 30 c. find the

What is the speed of the block when it has moved a distance : a 2.95 block on a horizontal floor is attached to a horizontal spring that is initially compressed 0.0380 . the spring

The microwave radiation left over from the big bang : the microwave radiation left over from the big bang explosion of the universe has an average energy density of 3.88

User Account

All Pages