Find the magnification of a microscope

Assignment Help Electrical Engineering
Reference no: EM13921879

1. A microscope has an objective with f = 1 cm, an ocular with f = 2.5 cm, and a distance s = 10 cm between them. Taking the best viewing distance as 25 cm,

a) Find the magnification of a microscope

b) Plot the picture of the rays to scale using the graph paper.

2. Model a parabolic graded-index fibre with n(r) = n1[1 - (r / a)2 Δ] for r ≤ a , with n1 = 1.5 , a = 0.1 mm and Δ = 0.01, by the equivalent multiple-step approximation. Divide the radius into 10 equal parts. Consider a ray inside the fibre crossing the fibre axis at 5o with respect to that axis. Using the graph paper, plot the progress of the ray through the fibre until it turns back and re-crosses the fibre axis. (Angles can be magnified on the plot.) At what value of r / a will the ray turn back? Does it depend on the value of a ?

3. In a step-index fibre, the refraction coefficients of the core and the cladding layer are 1.505 and 1.500, respectively.

a) Find the radius of the core, at which the fibre would perform as a single-mode at the wavelength of 1.3 μm, using a typical design criterion of V = 2 .

b) Find the cut-off wavelength for this fibre.

c) If the refractive index of the core was not 1.505 but 1.504, which cut-off wavelength (larger or smaller) would you expect?

Provide explanations.

(Note that a version of this problem in the handouts is incorrect. The correct version is above.)

4. Explain in your own words the difference between photoluminescence and electroluminescence.

5. Explain, why an LED operating at the fixed current would be more stable than that operating at the fixed voltage. Consider the effect of the device heating on the I(V) characteristics. Explain under which condition there would be positive or negative feedback from the heating.

6. A laser diode has a threshold current of 10 mA and a slope of its optical power versus input current of 2 mW/mA. The diode current is I = A + B sinω t . Plot the output power as a function of time if:
a) A=20 mA; B=2 mA;
b) A=10 mA; B=2 mA.

7. A p-n photodiode acts as a photocell, the circuit is shown in the handouts. Outline the band profile of the diode for infinitely large RL for different levels of illumination.

Reference no: EM13921879

Questions Cloud

Formulate an linear programming model : 1. Formulate an Linear Programming model for this problem 2. Create a spreadsheet model for this problem and solve it using Solver 3. What is the optimal solution?
Use technology to compute the mean of the prize amounts : On the TV show Deal or No Deal, a contestant chooses from among 26 suitcases, each containing a dollar amount. These dollar amounts are:
Write an essay on the pros and cons of tariffs : A five page (no less) essay on the pros and cons of tariffs. Must use three references from the Columbia Southern University library. APA formatted and MUST be original. It will be loaded to check for plagiarism.
Explain how the cap affects consumers and producers : Picture the effects of the price cap using a supply and demand graph. Explain how the cap affects consumers and producers.
Find the magnification of a microscope : Find the magnification of a microscope and plot the picture of the rays to scale using the graph paper - Explain in your own words the difference between photoluminescence and electroluminescence.
Formulate hrm strategies and policies to recruit, select : Determine the compensation that the fictitious company may provide to the separated employee.
What is difference between general and specific knowledge : What is the difference between general and specific knowledge? How can specific knowledge motivate the use of decentralized decision making?
What are contracting costs : What are contracting costs? Give a few examples of contracting costs. What effect does the existence of contracting costs have on market economies?
Explain process by which the banking system creates money : Assume that the bank holds no excess reserves and that the required reserve ratio equals 10% of deposits. If a customer deposits $5,000, what would be the total increase in checking account balances throughout all banks? Explain the process by whi..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the inductive reactance of the line per mile

Consider the three phase lines symmetrically spaced (fully transposed 7 meters apart using ACSR Dove conductor. Each phase has 4 conductors in a square bundle spaced 0.25 meters apart.  a. What is the inductive reactance of the line per mile (60Hz)..

  Find what is the work function of the material

Upon being struck by 240 nm photons, a material ejects electrons with a maximum kinetic energy of 1.67 eV. a) What is the work function of this material b) What is the largest wavelength of a photon that will eject electrons of this material

  Determine the dbm level for an output of 120mw

Determine the dBm level for an output of 120mW A power level of 100W is 6dB above what power level Find the output voltage of an amlifier if the applied voltage is 20mV and a dBv gain of 22 dB is attained

  Calculate the gain and bandwidth after the feedback

Single pole amp. has an open loop gain 10^6 and open loop bandwidth of 10Hz. If the feedback factor =1, calculate the gain and bandwidth after the feedback

  Determine the intial and final values of the waveforms

find the Laplace transformation to find the v(t) that satisfies the following firs-order differential equation : a) 500 dv(t)/d(t) +2500 v(t)= 0 , v(-0)= 100V b) dv(t)/d(t) +200v(t)= 400u(t)V , v(-0)= -100V

  What is the use of the carry output in parallel load counter

What is the use of the carry output in a parallel load counter If l have a 3 bit binary parallel load counter do l connectthe count input,and the outputs (Q) from the three flip flops

  Calculate value of multiplier resistor to obtain full scale

An AC Voltmeter uses a bridge rectifier and 100 ohm PMMC which requires a 1mA DC current for full-scale deflection. Assuming ideal diodes, calculate the value of the multiplier resistor to obtain full scale deflection with 10 V AC applied to the i..

  What is the current in the line feeding the three loads

Two machines and a lighting load are connected in parallel to a 240 V(rms), 60 Hz line. The first machine uses 230 kW of power at 0.85 power factor lagging. The second machine uses 95 kVA at 0.882 power factor leading. The lightening load consumes..

  What type of long-distance high-throughput wireless tech

The time has come for XelPharm to expand. The board of directors has purchased another warehouse for a second distribution facility. It's located in an industrial area, about eight miles from the company's headquarters.

  Determine the output voltage of an op-amp

Determine the output voltage of an op-amp for input voltages of Vi1=200uV at Vi2=140uV. The amplifier has a differential gain of Ad=6000 and the value of CMRR is A. 200 b. 10^5

  Explain at what point in lifecycle should process initiated

Cradle to death is a typical lifecycle for any given application. The useful life of a particular application will vary based on advancements in a given discipline. It is critical to continuously seek and identify new ways to adapt technology.

  What is minimum kva rating of each transformer in bank

The secondary's of a step-down, three-phase transformer bank are delta connected and supply a three-phase 240v moter that draws 12A through each line. What is the current in each transformer winding If the turn ratio of the transformers

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd