Find the intermediate pressure the turbine work the back

Assignment Help Mechanical Engineering
Reference no: EM13633319

A two stage compressor with intercooling between the stages is used to compress air from 1 bar and 150C to 9bar in a Gas-Turbine cycle . The high pressure turbine drives the compressor whereas low pressure turbine is coupled with an electrical generator. The compressor and each turbine efficiencies are 85%; 75%; and 75%,respectively. Heat is added to the compressed air after leaving the compressor till its temperature reaches 9000C. The air then expands in HPT to an intermediate pressure and reheat to the 9000C before expanding another time in LPT to 1 bar. Find the intermediate pressure, the turbine work, the back work ratio, and the cycle thermal efficiency. Assume 15 kg/s air flow rate.

Reference no: EM13633319

Questions Cloud

If in an observational study the statistical analysis has : if in an observational study the statistical analysis has shown convincing evidence that the mean levels differed in
Answer the following questions by checking either true or : answer the following questions by checking either true or false.a all other factors remaining the same a 90 confidence
The human body can survive an acceleration trauma incident : the human body can survive an acceleration trauma incident sudden stop if the magnitude of the acceleration is 250ms2.
A 0355 g sample of a solid monopractic acid having a : a 0.355 g sample of a solid monopractic acid having a molecular weight of 12gmol requires 18.47 ml naoh for
Find the intermediate pressure the turbine work the back : a two stage compressor with intercooling between the stages is used to compress air from 1 bar and 150c to 9bar in a
A proton accelerates from rest in a uniform electric field : a proton accelerates from rest in a uniform electric field of 640 nc. at some later time its speed is 1.20x106 ms. find
Caffeine c8h10n4o2is a stimulant found in tea and coffee a : caffeine c8h10n4o2is a stimulant found in tea and coffee. a sample of the substance was dissolved in 47.0 g of
Test the significance of the correlation coefficient r at a : test the significance of the correlation coefficient r at a 0.05 for the data below.x values 55 61 70 78 88y values 89
Assume that you have a box with an equal number of 4 6 8 : assume that you have a box with an equal number of 4 6 8 chips.a. find the population mean and the standard

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The operating temperature of sae 50oil p890kgm3 is to be

a full journal bearing360degree has a diameter of 10mm a length of 5 mm and supports load of 20 n. the sormmerfield

  A jeep tows a 400kg block uip a 45deg incline the

a jeep tows a 400kg block uip a 45deg incline. the coefficients of friction between the block and the ground are us0.6

  A satellite is in earth orbit with an altitude at perigee

a satellite is in earth orbit with an altitude at perigee of 555.0 km and an altitude at apogee of 1200.0 km.a. what is

  Steam at 16mpa and 400 degrees c is contained in a rigid

steam at 1.6mpa and 400 degrees c is contained in a rigid box. the system is then cooled to 200 degrees c. compare the

  Determine the minimum power required to operate this heat

a heat pump is used to heat a house and maintain it at 20 degc. on a winter day when the outdoor air temperature is -5

  Hydrogen at 25 bar 450degc enters an adiabatic turbine and

hydrogen at 25 bar 450degc enters an adiabatic turbine and expands to 2 bar 160degc with a mass flow rate of 0.2 kgs.

  What of diameter of steel rod is required to support tension

What of diameter of steel rod is required to support a tension load of 44.5kn?assume that the allowable stress for the steel is F=165n/mm.

  Two blocks a and b of mass 8 kg and 12 kg respectively hang

two blocks a and b of mass 8 kg and 12 kg respectively hang from a cable which passes over a pulley of negligible mass.

  Heat is now added to the air determine the work done by the

5 kg of air initially at 10oc and 100 kpa is in piston-cylinder device. initially the piston is resting on a set of

  When the vessel is under 9 psi of vacuum the height of the

a u-tube manometer is used to measure the pressure of a vessel under vacuum. assume the manometer is open to

  The working fluid at 23 degrees c rejects 100 kjmin as heat

the thermal efficiency of an internally reversible heat engine is 62 percent. the working fluid at 23 degrees c rejects

  What sets of planes diffract the x-rays

Titanium in the BCC structure has a radius of 0.1423 nm.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd