Find the heat transfer and work per unit mass of air in

Assignment Help Mechanical Engineering
Reference no: EM13633510

Consider an air-standard Otto cycle, and a modified cycle in which the isentropic compression and expansion processes are each replaced by polytropic processes with n=1.3. The compression ratio for both cycles is 10. P1 = 1 bar and T1 = 310 K, and the max temperature of the cycles is 2200 K. Find the heat transfer and work per unit mass of air in KJ/kg for each process of the two cycles, and compare the thermal efficiency of each. Assume constant specific heats at room temperature, and k=1.4.

Reference no: EM13633510

Questions Cloud

The osmotic pressure of 1800 ml solution of : the osmotic pressure of 180.0 ml solution of sucrosec12h22o11 in ethanol at28.0degc is 1.85 atm. what is the molar
We know that the average life of a light bulb is 10000 : we know that the average life of a light bulb is 10000 hours.there are 12 lightbulbs in a classroom. in order for a
The sun emits light waves with a power of 4x1026 watts : the sun emits light waves with a power of 4x1026 watts. determine the intensity of light waves from the sun just
An organic compound molar mass97 is dissolved in water to : an organic compound molar mass97 is dissolved in water to form asolution with a density of 1.05 gml and a molarity of
Find the heat transfer and work per unit mass of air in : consider an air-standard otto cycle and a modified cycle in which the isentropic compression and expansion processes
What is the probability of a randomly selected credit card : assume credit card balances are normally distributed with a mean of 2870 and a standard deviation of 900 - assume these
The bullet then emerges on the other side of the board with : a bullet is fired through a wooden board with a thickness of 11.0 cm. the bullet hits the board perpendicular to it and
Why is h2so4 the limiting reagent i understand you divide : why is h2so4 the limiting reagent. i understand you divide 2by 3 multiplied by the number given but i just get that one
A survey found that people who took coldeeze at the onset : a survey found that people who took coldeeze at the onset of a cold suffered on average 42 hours. what proportion of

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Explain horsepower and efficiency of three-phase motor

Horsepower and efficiency of three-phase motor, If a fully loaded 440V, three-phase motor draws 12.4 A at 86% power factor (pf). It's speed is 1730 rpm and its torque output to a mechanical load is 29.1 lb-ft x 1.356 = 39.5 Nm.

  Calculate the maximum mass flow rate at the inlet condition

a refrigerant 134a at 140 kpa and -10 degree celcius is compressed by an adiabatic 16kw compressor to an exit state of

  Calculate the speed of the flow at the nozzle exit and the

water at 15 degrees celcius flows through a nozzle that contracts from a diameter of 20cm to 2cm. the pressure at

  Prepare the project objectives based on the requirement out

prepare the project objectives based on the requirement out lined at the next page.the following is the project

  The compression ration in an air-standard otto cycle is 8

the compression ration in an air-standard otto cycle is 8. at the begining of the compression stroke the pressure is

  Steam at 1 bar enters an adiabatic heat exchanger with a

steam at 1 bar enters an adiabatic heat exchanger with a quality of 0.896 and exits as a saturated liquid. the steam is

  Determine the net force acting on block a using newtons 2nd

a downward force of 98 n acts on the free end of the illustrated pulley. ma 47 kg what is block as acceleration?

  What is the flow rate of cell suspension from the membrane

a battery of cylindrical hollow-fiber membranes is operated at steady state to concentrate a bacterial suspension from

  A helical compression spring is made of no 18 0147 in wire

a helical compression spring is made of no. 18 .0147 in wire having a torsional yield strength of 108 kpsi. it has an

  Determine the dimentionless parameters that characterize

determine the dimentionless parameters that characterize the average velocity of the flow in a smooth pipeline if the

  Hydrogen at 25 bar 450degc enters an adiabatic turbine and

hydrogen at 25 bar 450degc enters an adiabatic turbine and expands to 2 bar 160degc with a mass flow rate of 0.2 kgs.

  A man of mass m1 walks along a plank of length l with a

a man of mass m1 walks along a plank of length l with a constant acceleration a relative to the plank. the mass of the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd