Find the exit temperature of the air in degc find the

Assignment Help Mechanical Engineering
Reference no: EM13631384

Refrigerant-22 is condensed from 120°C, 1.40 MPa to saturated liquid using air at 24°C, 1.00 bar. The air absorbs 72,000 kJ/hr of heat. The air flow rate is 25 times that of the refrigerant.

a. Find the mass flow rate of refrigerant in kg/sec.

b. Find the exit temperature of the air in °C.

c. Find the velocity of the air at the exit (m/s) if it is flowing through a rectangular duct that is 25 cm x 50 cm.

[If you could not do part a, you may take the mass flow rate of refrigerant to be 0.2 kg/s]

Reference no: EM13631384

Questions Cloud

If the pot is initially full of saturated water at 200 kpa : a six liter 6 l pot is fitted with a heavy lid that allows a maximum of 200 kpa of absolute pressure. heat is added to
A find the wavelength of the sound upwind of the siren b : a find the wavelength of the sound upwind of the siren.b find the wavelength of the sound downwind of the siren.c
Assuming the ideal gas model for the air determine the : two kilograms of air within a piston cylinder assembly execute a carnot power cycle with maximum and minimum
A 86-mw vertically polarized laser beam passes through a : a 86-mw vertically polarized laser beam passes through a polarizer whose polarizing angle is 25deg from the horizontal.
Find the exit temperature of the air in degc find the : refrigerant-22 is condensed from 120degc 1.40 mpa to saturated liquid using air at 24degc 1.00 bar. the air absorbs
Two polarizers are out of alignment by 30deg if light of : two polarizers are out of alignment by 30deg. if light of intensity 7.57 wm2 and initially polarized halfway between
Every day our earth receives 155times1022 j energy from the : how much energy is required to accelerate a spaceship with a rest mass of 107 metric tons to a speed of 0.453 c?every
What constant force must be exerted on the rope to bring : a 150 kg merry-go-round in the shape of a uniform solid horizontal disk of radius 1.50 m is set in motion by wrapping a
Determine the dynamic viscosity of flow if the pressure : determine the dynamic viscosity of flow if the pressure drop of a fluid running with a flow rate of 880 mm3s through a

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  In a railroad switchyard a 50 ton freight car is sent at 74

in a railroad switchyard a 50 ton freight car is sent at 7.4 mih toward a 27 ton car that is moving in the same

  A hot rolled shaft is subjected to torsional load that

a hot rolled shaft is subjected to torsional load that varies from 320 nm clock wise to 120 nm anti -clockwise and an

  The tunnel is located in boulder colorado altitude 1650 m

an intermittent wind tunnel is designed for a mach number of 4 at the test section. the tunnel operated by sucking air

  A motorist decreases the speed of an automobile at a

a motorist decreases the speed of an automobile at a constant rate from 45 to 30 mih over a distance of 750 ft along a

  A large vessel had experienced an internal leak of a

a large vessel had experienced an internal leak of a coolant. it was friday and the work crew needed to get the vessel

  Hydrogen at 25 bar 450degc enters an adiabatic turbine and

hydrogen at 25 bar 450degc enters an adiabatic turbine and expands to 2 bar 160degc with a mass flow rate of 0.2 kgs.

  Steam at 95 bar and 400 c is supplied in turbine the

steam at 95 bar and 400 c is supplied in turbine. the condenser pressure is 0.035 bar. if the plant operates as a

  The overall rise in the pipe from tank to trough is 3 feet

1 a 3-inch nominal size cast iron pipe has an actual inside diameter of 3.58 inches. the pipe is 5000 feet long and

  Determine the specific volume for the following saturated

determine the specific volume for the following saturated water a 15 psi x0.5 b 90 psi x0.4 c 145 psi x0.3 d 650 psi

  A large number of concrete slabs each 06 m in length are

a large number of concrete slabs each 0.6 m in length are lined up with a spacing of 0.1nbspmm between them. the

  Explain the maximum flow past a circular cylinder

The maximum flow past a circular cylinder is 2 X the Up stream velocity. The max velocity occurs at the center line of the top of the cylinder.

  Determine the radius in m and the mass in kg of an

a disk-shaped flywheel of uniform density r outer radius r and thickness w rotates with an angular velocity v in rads.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd