Find the equation of motion of the uniform rigid bar

Assignment Help Mechanical Engineering
Reference no: EM13992027

Problem 1

A mass m is attached at the end of a bar of negligible mass and is made to vibrate in three different configurations as shown in Figures (a), (b) and (c). Find the configuration corresponding to the highest natural frequency. What would you conclude from your findings?

2170_Configurations.jpg

Problem 2

Find the equation of motion of the uniform rigid bar OA of length l and mass m shown in the figure.

Note:IG = ml3/12

348_Uniform rigid bar.jpg

Problem 3

A single-degree-of-freedom system consists of a mass of 20 kg and a spring of stiffness of 400 N/m. The amplitudes of successive cycles are found to be 50, 45, 40, 35, .... (mm). Determine the type of damping and the magnitude of the damping force. Assume the velocity of the mass at time zero is zero.

Problem 4

Will the force transmitted to the base of a spring mounted machine decrease with the addition of viscous damping? Explain.

Problem 5

A machine having a mass of 140 kg is mounted as shown on springs having a total stiffness of 45,000 N/m. The damping factor is ξ = 0.30. A harmonic force P = 500 sin 15t (with Pin newtons and t in seconds) acts on the mass.

183_Uniform rigid bar1.jpg

For the sustained steady-state vibration, determine:

(a) The amplitude of the motion of the machine

(b) Its phase with respect to the exciting force

(c) The transmissibility

(d) The maximum dynamic force transmitted to the foundation

(e) The maximum velocity of the motion

Reference no: EM13992027

Questions Cloud

Problem regarding the job-related injury : Elwood had to retire early because of a job-related injury. During the current year, he receives $10,000 in Social Security benefits. In addition, he receives $6,000 in cash dividends on stocks that he owns and $8,000 in interest on tax-exempt bon..
Problem regarding the unemployment benefits : John is unemployed. During the current year, he receives $4,000 in unemployment benefits. Because the unemployment is not enough to live on, John sells drugs to support himself. His total revenue for the year is $120,000. The cost of the drugs is ..
Calculate the maximum deceleration of a car : Calculate the maximum deceleration of a car that is heading down a 11° slope (one that makes an angle of 11° with the horizontal) under the following road conditions.
Best breakthrough idea of the year : During the current year, he publishes a paper that explains the design of a revolutionary new chip. Softmicro, Inc., awards him $10,000 for the best breakthrough idea of the year. Sook uses the money to purchase a computer workstation to use in hi..
Find the equation of motion of the uniform rigid bar : Find the equation of motion of the uniform rigid bar and Will the force transmitted to the base of a spring mounted machine decrease with the addition of viscous damping?
Problem regarding the common stock of nishida : Devi is the chief executive officer of Nishida Limited. Devi owns 20% of the common stock of Nishida. During the current year, Devi's salary is $60,000 and he receives a $30,000 bonus. Nishida has taxable income of $200,000 and pays $80,000 in ca..
Cam rental corporation and transfers : Camille owns several rental properties that produce $3,000 in income each month. Because of the age of the properties, Camille is concerned about her potential liability from accidents on the property. On June 1, she forms the CAM Rental Corporati..
Frank gives the pujan stock to dorothy : Frank owns 1,000 shares of Pujan stock. On May 1, Pujan declares a $12-per-share dividend to shareholders of record as of June 1. On May 15, Frank gives the Pujan stock to Dorothy. She receives the $12,000 dividend on June 30.
Calculate the maximum acceleration of a car : Calculate the maximum acceleration of a car with four wheel drive that is heading up a 8.5° slope (one that makes an angle of 8.5°with the horizontal) under the following road conditions.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Determine the absolute pressure in the chamber

A vacuum gage connected to a chamber reads 35 kPa at a location where the atmospheric pressure is 92 kPa. Determine the absolute pressure in the chamber.

  Estimate the jet velocity relative to the airplane

The GE J-79 turbo jet produces a thrust of 10,000lbs at sea level. The inlet diameter is 3.19 ft. If an airplane equipped with the J79 is flying at standard sea level with a velocity of 1,000 ft/sec, estimate the jet velocity relative to the airplane..

  Two meshing helical gears have a 25 degree transverse

two meshing helical gears have a 25 degree transverse pressure angle and a 20 degree normal pressure angle. the gears

  Determine the relative humidity and the humidity ratio of

air at 100 o f and 14.7 psia has a dew point temperature of 70o f. determine the relative humidity and the humidity

  Vapor compression refrigeration cycle

A vapor compression refrigeration cycle is used. The working fluid is R134a. The fluid at the compressor inlet is a superheated vapor with a pressure p1 = 200 Kpa   and a temperature T1 = 10°C. The compressor pressure ratio p2/p1 = 8, the fluid exits..

  A 250 mm diameter x 25 mm width grinding wheel operates at

a 250 mm diameter x 25 mm width grinding wheel operates at 2600 revmin in-feed is 0.05 mmpass cross-feed is 3.50 mm.

  The mole percents of the compounds are as follows 78 n2 21

air in the atmosphere is composed of primarily nitrogen oxygen and argon. the mole percents of the compounds are as

  An air plane with constant altitude and velocity is being

an air plane with constant altitude and velocity is being detected by a radar. the radar keep computing the distance d

  Fluid a available at 10oc is to be heated in a

fluid a available at 10oc is to be heated in a one-shell-pass four-tube-pass exchanger heat using fluid b available at

  Scenarioprepare a power point presentation and a short

scenarioprepare a power point presentation and a short report relating to the capabilities of solidworks motion

  Water at 4oc is to be delivered to the top of a ski area

water at 4oc is to be delivered to the top of a ski area for snowmaking purposes. the water is to be drawn from a

  The average plate temperature of a flat plate of length l

the average plate temperature of a flat plate of length l with constant heat flux with air at 20?c flowing over it at a

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd