Find the compressor and turbine specific work

Assignment Help Mechanical Engineering
Reference no: EM13873304

A modern jet engine has a temperature after combustion of about 1500 K at 3200 kPa as it enters the turbine section, see state 3 Fig. P.6.107. The compressor inlet is 80 kPa, 260 K state 1 and outlet state 2 is 3300 kPa, 780 K; the turbine outlet state 4 into the nozzle is 400 kPa, 900 K and nozzle exit state 5 at 80 kPa, 640 K. Neglect any heat transfer and neglect kinetic energy except out of the nozzle. Find the compressor and turbine specific work terms and the nozzle exit velocity.

Reference no: EM13873304

Questions Cloud

Identify a specific environmental public health issue : Identify a specific environmental public health issue in the community
Describe the mechanisms between different types of drugs : Explains in detail the differences and commonalities in mechanism of action between Histamine-2 antagonists, antacids, and proton pump inhibitors and Describes multiple adverse effects the patient should be aware of while taking the prescribed med..
What other issues that may occur when using ppe? : What other issues that may occur when using PPE?
What are the inputs to and outputs of a supply chain : What are the inputs to and outputs of a supply chain? Why do you suggest this supply chain structure in the given situation? What are its benefits?
Find the compressor and turbine specific work : Neglect any heat transfer and neglect kinetic energy except out of the nozzle. Find the compressor and turbine specific work terms and the nozzle exit velocity.
Measure the pressure inside : A mercury manometer (r = 13,600 kg/m3) is connected to an air duct to measure the pressure inside. The difference in the manometer levels is 15 mm, and the atmospheric pressure is 100 kPa.
What is minimum delay between saying and getting a response : What is the minimum delay between saying something and getting a response? I know the radius between the satellite and the center of the earth, but I don't know how to find the delay.
Doubtful accounts of the master company : During 2010, uncollectible receivables amounting to $410,000 were written off against the allowance for doubtful accounts.
Develop a matrix for assessing an aspect of the project : Please develop a risk assessment matrix for The Briargrove Project. Develop a Matrix for assessing an aspect of the project.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Describe the basics of the carnot cycle of thermodynamics

describe the basics of the carnot cycle of thermodynamics and its application to heat engines such as diesel engines

  The man pulls the boy up to the tree limb by walking

the man pulls the boy up to the tree limb by walking backward. if he starts from rest when 0 and moves backward with a

  Calculate the rate of heat transfer from this plate

A thin flat plate 6in square with a surface temperature maintained at 250°F is tested for drag in a wind tunnel with an airspeed of 100ft/s. The air is at standard sea level pressure and 60°F and flows over the top and the bottom of the plate. This f..

  Operating from sea level atmospheric inlet conditions

Ideal Otto and Brayton cycles are operating from sea level atmospheric inlet conditions and a pressure ratio 15:1. Find the thermodynamic efficiencies (nth) for these two cycles. There should be two answers

  Determine the final volume m3 of the water in the tank

initially an insulated rigid tank contains 3.73 kg of water at 240oc and 1 mpa. a heater in the wall of the tank

  What is the entropy change of the flame

You are boiling a kettle of water over a propane stove that is supplying a uniforma amount of heat. You note that it takes 3 minutes to heat water which is initially at 20C to its boiling point. Just as the water begins to boil, you receive a phone c..

  A pressure gage connected to a tank of oxygen reads 50 psi

a pressure gage connected to a tank of oxygen reads 50 psi and the temperature of the oxygen is 80degf. if the local

  Determine the rate of entropy production in kwk for an

at steady state work at a rate of 5 kw is done by a paddle wheel on a slurry contained within a closed rigid tank.

  What is the frequency of the motion what is the amplitude

a 5.70kg block hangs from a spring with spring constant 1900nm . the block is pulled down 6.80 cm from the equilibrium

  Calculate the magnitude of mans acceleration

If the speed of the man at A (XA = 5m and YA = 1m) is VA = 9 m/s and the increase of his speed is dVA/dt = 13 m/s2, calculate the magnitude of his acceleration and the slop angle at this point.

  At steady state a commercial freezer maintains its interior

at steady state a commercial freezer maintains its interior temperature of -shy30f by rejecting heat to the

  Engine and nozzle problem

Consider a rocket engine with a convergent-divergent nozzle operating at sea level. The pressure in the combustion chamber is Pc= 10 MPa, with a combustion temperature of Tc= 2400 K. The static pressure measured in the throat of the rocket nozzle is ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd