Find the complex voltage gain of the amplifier

Assignment Help Electrical Engineering
Reference no: EM13229134

input voltage to an amplifier is: Vi(t)=0.1*cons(2000*pi*t+30) and the output voltage is: Vo(t)=10*sin(2000*pi*t+15) Find the complex voltage gain of the amplifier at f = 1kHz and express the magnitude of the gain in decibels.

Reference no: EM13229134

Questions Cloud

What caused you to depart from your own standards : Do you think that acting ethically is just a matter of wanting to badly enough? Why or why not and what kinds of situational factors can you think of that might make it difficult for a well-intentioned person to always do the right thing?
Determine the mid point of the voltage divider : An n-channel JFET needs a NEGATIVE voltage applied to its GATE, relative to its SOURCE. If you have a single POSITIVE supply applied to the MASTER loop of a JFET, the mid point of the voltage divider will also be a positive voltage
Explain the bicyclist and the balloon increasing : A bicyclist passes beneath it, traveling in a straight line at the constant speed of 10 m/sec. How fast is the distance between the bicyclist and the balloon increasing 2 seconds later?
Describing the management approach : In 50 or fewer words write a statement describing the management approach you believe will motivate and coordinate your subordinates, and tell why you think this style be best.
Find the complex voltage gain of the amplifier : input voltage to an amplifier is: Vi(t)=0.1*cons(2000*pi*t+30) and the output voltage is: Vo(t)=10*sin(2000*pi*t+15) Find the complex voltage gain of the amplifier at f = 1kHz and express the magnitude of the gain in decibels.
Which configuration then would have higher input impedance : The input impedance of a JFET used in COMMON SOURCE configuration, is defined by two considerations: The JFET itself has a VERY HIGH INPUT IMPEDANCE, because the input is the GATE to SOURCE junction that is REVERSE biased
Explain differ from an electron with quantum numbers : Assuming electrons with quantum numbers (n,l,mt,ms), how does an electron with the quantum numbers (2,1,1,+1/2) differ from an electron with quantum numbers (2,1,-1,+1/2)?
Construct a canonical sum of products-sop expression : A farmer owns two barns; one north of a creek and the other south of the creek. The farmer has a Cabbage, a Goat, and a Wolf. The Farmer needs to put each item in a barn every night. If the Cabbage and Goat are in the same barn
Define the bargaining unit as technical workers : In order to win, the UAW would propose to restrict the bargaining unit to assembly workers and Jack would propose to define the bargaining unit as technical workers, janitors, and assembly workers.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the value of the unknown resistance

A series-connected circuit has a 240-V voltage source, a 10- resistance, a 5- resistance, and an unknown resistance Rx. The voltage across the 5-? resistance is 30 V. Determine the value of the unknown resistance.

  What is the value of the smallest resistor

The voltage drops across three resistors in series are measured to be 10.0V, 15.0V, and 25.0V. If the largest resistor is 47.0 ?, what is the value of the smallest resistor?

  Convert the temperature range into an 8-bit digital word

Devise a system that will convert this temperature range into an 8-bit digital word with conversion from 00H to 01H at 200°C and from FEH to FFH at 350°C . An ADC is available with a 2.500-V internal reference. At 200°C a type K TC produces 8.13 m..

  Realize the storage circuits for n1 and n2

Realize the storage circuits for N1 and N2 as describe in the design specification.

  Traffic light controller

The schematic of the traffic light controller

  Which requires more harmonics to accurately model

Which requires more harmonics to accurately model it (triangle, square, and sawtooth) and why?

  Define maximum amount of channels a link can carry

Maximum Amount of Channels A Link Can Carry, A microwave radio link operates over a bandwidth of 400 MHz at C band. The link carries a number of channels of data using FDMA.

  Identify the number of required jk d-flip flop

Design a counter that will execute the numerical sequence 0, 2, 4, 6,repetitively. Unwanted states should be directed into wanted states that give the simplest logic functions. - Identify the number of required JK D-FLIP FLOP;

  What is speedup in throughput for each of these improvements

Increasing the number of SIMD processors to 15 (assume this change doesn't affect any other performance metrics and that the code scales to the additional processors)

  Determine what is the phase angle in degree

an electric motor has an armture constant of 140, a flux of 25 mwh, an armuture current of 30 A , and a rotatio?nal speed of 1600 rpm. what is most nearly the power output in watt

  Calculate the signal to noise ratio given rms noise voltage

1. Given R = 50Kohm and C = 100nF what is the frequency of oscillation 2. Given a required frequency of oscillation of f = 10kHz and R = 8kohm, what should the value of C be Calculate the signal to noise ratio given RMS Noise Voltage = 20mV and RMS S..

  Develop equivalent circuits for the 741 as current amplifier

The 741 op amp is usually modeled on specification sheets as a voltage amplifier having the following parameters: Rin = 1 M, Av = 100,000, and Rout = 100  Using this information, develop equivalent circuits for the 741 as a current amplifier

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd