Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
a load made up of a 100 ohm resistor in series with a 20 nF capacitor is connected across a 2400V (rms), 60 Hz voltage source. Find the complex power being delivered to the load and the power factor. state whether it is lagging or leading.
(a)find the work done in moving a point charge +2C from (2,0,0) to (0,2,0) and then from (0,0,0) to (0,2,0). (b)find the work done in moving a point charge +2C from (2,0,0) to (0,2,0) along the straight-line path joining the two points.
The amount of three phase power to be delivered in ‘kW' is equal to the total number of letters in your name (first name +last name) and the single phase power is 10% of three phase power. Assume same power factor for both types of loads.
Convert the first-order Butterworth low-pass prototype, H(z) = 1 / s+1 to a digital IIR filter using impulse invariant method when sampling frequency is 1 Hz.
The manufacturer of commercial jets has a cost index equal to 94.9 per aircraft in 2009. the anticipated cost index for the airplane in 2014 is 106.8. the avaerage compound rate of growth should hold steady for the next 15 years.
An otherwise-ideal op amp, known to have an open loop gain of 10^4 V/V , is measured in a circuit to have an output voltage of -3 V. While it would be difficult to measure, what would you expect the voltage from the negative terminal
what do u mean by term slip of three phase induction motor calculate the slip of 4-pole induction motor running at 1470 rpm while bieng connected to a 50 hz three phase source
In a particular IC design in which the standard channel length is 2µm, an NMOS device with W/L of 5 operating at 100µA is found to have an output resistance of 0.5MO, about 1/4 of that needed.
A collector modulated transmitter has a supply voltage of 48 V and an average collector current of 600 mA. What is the input power to the transmitter. How much modulating signal power is needed to produce 100 percent modulation
A process has dynamics G(s)=1/(4s^s+s+1). Apply a unity negative feedvack controller of the form G.c(s)=1/(s+b). (a) Report the transfer function T(s) of the closed-loop system. (b) Report T(s) to 2nd order and report the reduced transfer function T..
A function generator is adjusted to give a 60 HZ sine wave with no-load (open-circuit) voltage of 3Vrms. When a 1k ohm load is place across the output terminals of the function generator, the output voltage drop to 8Vpp.
Determine the 8-bit sign-and-magnitude, 1's complement, and 2's complement representations for each of the following decimal numbers: +36, -84. (Note: Be sure to represent +36 as a positive number and -84 as a negative number.)
The peak voltage is 6V and you need to maintain a resolution of 0.034V. Find the number of bits per sample and then calculate the total number of kbps needed in the ADC. Remember that you cannot have a fraction of a bit in a sample.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd