Find the angle of incidence on the ionospheric layer

Assignment Help Electrical Engineering
Reference no: EM13276986

Design an ionospheric radio link over a distance of 2500 Km given that the ionosphere effective height is 275 Km and the electron density N= 2*1011 /m3, namely find :

i- the angle of incidence on the ionospheric layer.

ii- choose a suitable operating frequency (Hint: use f=.85 fMUF).

iii- the required antenna height.

iv- at night N is reduced to 5*1010, find the new operating frequency.

Reference no: EM13276986

Questions Cloud

Find the current distribution and the length of the array : Design a continuous antenna array to have the following soace factor : [(sin(2πcosθ))/(2πcosθ)] , at a  wavelength λ=.5 m namely,find : i- the current distribution and the length of the array. ii-the relative side lobe level.
Design a uniform ordinary end-fire array to have a hpbw : Design a uniform ordinary end-fire array to have a half power bandwidth (HPBW) no greater than 100°, namely : i- find the number of elements N, take the inter-element spacing d=λ/8. ii- find the relative side lobe level.
What is the potential energy of the loop : A round loop of diameter 12 cm, carrying a current of 0.40 A, is placed inside a magnetic field B = 0.20 i T + 0.40 j T. What is the potential energy of the loop
Assume equal population standard deviations : What is the critical value of t for the claim that the difference of two means is less than zero with α = 0.025 and sample sizes of nine and seven? Assume equal population standard deviations.
Find the angle of incidence on the ionospheric layer : Design an ionospheric radio link over a distance of 2500 Km given that the ionosphere effective height is 275 Km and the electron density N= 2*1011 /m3, namely find : i- the angle of incidence on the ionospheric layer.
Find the ratio tmagenta to tyellow : A soap film with different thicknesses at different places has an unknown refractive index n and air on both sides. Find the ratio tmagenta/tyellow
Find the receiving antenna gain in order to secure a c-n : In a line of sight link , the transmitted power = 1 watt at the frequency of 11 GHz and the transmitting antenna has gain of 1000 , the receiving antenna is 40 Km apart from the transmitting station
King of hearts : Two identical pack of cards A and B are shuffled throughly. One card is picked from A and shuffled with B. The top card from pack A is turned up. If this is the Queen of Hearts, what are the chances that the top card in B will be the King of Hearts?
Determine the total electric potential at the origin : Two point charges are on the y axis. A 3.80-µC charge is located at y = 1.25 cm, and a -2.18-µC charge is located at y = -1.80 cm. Find the total electric potential at the origin

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the vector of the electric field e at point p

A thin ,non conducting line of charge lies along the x axis. One end is at x=-1.00m and the other end is at x=+1.00m. The total charge on the line is 5.00 µC. calculate the vector (magnitude and direction) of the electric field E at point P due to ..

  Find minority carrier concentration at emitter-base junction

A Si p-n-p transistor has impurity concentrations of 5´1018, 2´1017, and 1016 cm-3 in the emitter, base, and collector, respectively. The base width is 1.0mm, and the device cross-sectional area is 0.2 mm2.

  Define a design of a series controller

Design a series controller (a PD, PI or PID) so that the following performance specifications are satisfied. Steady-state error due to a step input = 0

  Find transmission bit rate

A 4KHz audio signal is transmitted by using a PCM system and the quantization level, L is 256. Find transmission bit rate.

  What is maximum possible value for equivalent capacitance

The series combination of a 4=mu F and a 3mu F capacitor is in series with the parallel combination of a 2 mu F, a 1 ? mu F, and a C - mu F capacitor, (a) What is the maximum possible value for the equivalent capacitance of the five capacitors

  Implement a circuit equivalent to a d-type flip-flop

Suppose you have a need for a D type flip-flop, but only have access to T type flip-flops. Implement a circuit equivalent to a D-type flip-flop with a t-type flip-flop and some extra logic gates.

  Design a plc program and prepare a typical i/o connection

Each start/stop station contains one NO start pushbutton and one NC stop pushbutton.

  What is the internal resistance of the battery

When the starter motor, which draws 90A, is running the terminal voltage drops to 11V. What is the internal resistance of the battery What percentage of the chemical power is delivered to the starter motor

  What determines minimum firing angle at the rectifier side

1.The Thyristor is a natural commutation device. What does that mean. 2.Mention two reasons why the HVDC might be your choice as a power system designer to transfer large amount of power.

  Calculate the increase in speed in rpm during the interval

Suddenly there is a short-circuit on the electric grid, and the electrical output goes to zero for 2 seconds. Calculate the increase in speed in rpm during this interval. Assume that the shaft-torque remains constant

  Calculate what is the rated armature current

A dc machine is rated 5 hp with V_f = 240 V, V_a = 240 V, r_a = 0.63 ohms, and L_AF = 1.8 H. At rated condtions w_r = 127.7 rads/s and the total resistance of the field circuit is 240 ohms. a) Calculate the rated armature current.

  Calculate the voltage across each element

A resistance of 40 ohms is connected in series with an inductance of 0.12 H. Calculate the current, power, reactive power, apparent power, and power factor when the combination is connected to a 60 Hz, 120 V source.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd