Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In a RLC circuit, the generator voltage varies in time, where the amplitude of e max= 1.2 volt and emf freq.= 0.5 Hz , which the max current is equal to the max current when the freq. of emf = 3.0 Hz, which is .00033 A. In addition, when emf freq. is 0.97 Hz, the maxI = .074 A. The inductance = 30.9 mH.
Find the amount of "time" passes between the max energy in inductor and max energy stored in capacitor
A constant(dc) current i(t)=3mA flows into a 50x10^(-6) capacitor. The voltage at t=0 is v(0)= -20V. The references for v(t) and i(t) have the passive configuration. 1. find the power at t=0 2. state whether the power flow into or out of the capaci..
The maximum ratings for all resistors of this type are 250 (V) and ½ (W). What range of resistance values are limited by the maximum voltage rating of 250 (V), and what range of resistance values are limited by the maximum power of ½ (W)
Power Electronics: A Single-Phase Bridge Rectifier, A single-phase bridge rectifier has a purely resistive load R=10 Ohms, the peak supply voltage Vm=170 V
The common crystal used in older color teleisions outputs a 3.58002 MHz signal. What is the MOD number required for a counter to reduce this to a 60Hz output
What is the reliability, the equivalent MTBF value, and the equivalent failure rate for a system that has a primary microprocessor circuit board and a secondary microprocessor circuit board that is hooked up in standby redundancy
A 75-kVA, 230-V/115-V, 60-Hz was tested with these results: Open-circuit test: 115 V, 16.3 A, 750 W; Short-circuit test: 9.5 V, 326 A, 1200 W a) Determine the voltage regulation at rated load, 0.8 power factor lagging.
A 3-phase, 20 kVA, 208 V, 4-pole star-connected synchronous generator has a synchronous reactance of Xs = 1.5 ohm per phase. The resistance of the stator winding is negligible. The machine is connected to a 3-phase 208 V infinite bus.
A 15hp (output power), 208V, three phase, six pole, y-connected induction motor has the following parameters: R1 = 0.1 ohm R'2= 0.1 ohm Xeq = 0.5 ohm A.) A fan type load is connected to the motor. The slip of the motor in this case is 2%.
A transmission line has a resistance of 0.001 pu , and 0.01 p.u reactance. Voltages at the both ends (p and q) of the transmission line are 1.0p.u each. Angle at bus "p" is 45o and the angle at bus " q" is 30o.
A 1 kHz sine wave signal with a power level -10 dBm is applied to the input of the amplifier. What is the power at the amplifier output in dBW?
Why can't a video signal such as an NTSC analog television signal be transmitted over a two km length of loaded twisted pair cable with a frequency range 300 Hz to 3,400 Hz? What is the bandwidth occupied by an NTSC video signal?
1.How is crude oil formed ?How is it found/discovered ? 2.How is natural gas formed? (Start with plankton) and include crude oil formation.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd