Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 4800/480 volt, single phase transformer is rated at 75KVA. test results performed for rated power showed the following. short circuit test V=80v, P= 2470W, I= Rated current open circuit test V= 480v, I=4Amp, P=616W Find the all day efficency at a power factor of .9 lagging if the load is as follows 8 hours full load 8 hours half load 8 hours 0 load
What is the PIV required of the diode? A half-wave rectifier employing a 12-V-rms 60-Hz sine-wave source and no dc load is filtered using a polarized electrolytic capacitor having a small leakage current.
What is the resistivity of the wire? conductivity? Using the original dimensions of the wire, how much current can you pass through the wire until a 5V signal is degraded 5% or more?
The woofer can be modeled as a series R-L low pass filter. Suppose that a given woofer has an inductance of 750 micron Hertz and a resistance of 4 Ohms. At what frequncy (in Hertz) does its frequncy response
A 5 KVA 480/120 V single phase transformer is to be used as an autotransformer to transform a 600 V source to a 480 V supply. As a single phase transformer delivering rated load at 0.8 PF Lag its efficiency.
Transmitting data at higher speeds generally requires a wider bandwidth, which is not always possible within FCC guidelines. In addition to the wider bandwidth, higher speed transmission also requires a higher transmit power. Why
How tall must the antennas be if the link operates on a frequency of 2.450Ghz, D1=5miles, D2=11miles, and the obstruction is 60 feet high?
The circuit will have as inputs a minimum of two inputs; the binary equivalent of two decimal numbers of not greater than (10,000)10. The circuit will also produce a minimum of two outputs, the quotient and the remainder.
Assume the acceptable deviation is +- 5.8%. Thus, a nominal rms voltage of 120 V will range from 113 to 127 V. Suppose the line to line voltage at Customer A is 13.8kV, the load at customerA consumes complex power (1.2+j1.2)x 10^6 W.
If L=0.0053nH, C=15µF find the operating frequency of series LC circuit. What factors decides capacitance? Explain using diagram.
What value of emitter resistor would you choose, if: a) You have to amplify the signal of a microphone that has an internal resistance of 100K using a Common Emitter bias configuration b) you have to drive a load of 50 with an Emitter Follower cir..
Develop with MATLAB, a fuzzy control system for controlling the power of a motor (0-350 rpm) based on the supported load (0-1700 lbs) thereby that at greater load develops more power. The system must contain at least 5 rules, but preferably 7.
A 250hp, 500v dc shunt motor draws a nominal field current of 5A under rated load. The resistance is 90ohms. Calculate the ohmic value and power of the series resistor needed so that the field current drops to 4.5A
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd