Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A Y-connected synchronous generator rated 100 MVA, 13.2 kV has a rated impedance of R = 5% and XS = 80% per-unit. It is connected to a j10Ω transmission line through a 13.8/120 kV, 100 MVA, Δ-Y transformer with a rated impedance of R = 2% and X = 8% per unit. The base for the power system is 200 MVA, 120 kV at the transmission line.
(a) Sketch the one-line diagram of this power system, with symbols labeled appropriately.
(b) Find per-unit impedance of the generator on the system base.
(c) Find per-unit impedance of the transformer on the system base.
(d) Find per-unit impedance of the transmission line on the system base.
(e) Find the per-phase, per-unit equivalent circuit of this power system.
A reciprocal 2 port microwave device has vswr of 1.5 andan insertion loss of 2db. Find the magnitudes of S- parameters forthe device.
Compare the differences in the FFT result. Explain why even though the inputs to both FFTs are the same cosine waves, the shapes of the FFTs are different.Compute and plot the 128 point FFT of a 0.125Hz cosine wave
Assume you have a 3-bit pre-packaged counter. You cannot modify thecounter except for hooking logic to the inputs and outputs. Thecircuit has synchronous load and synchronous reset control inputs.The loadable inputs are a2, a1, and a0 (with a2 as ..
A four DC shunt generator has Φ=.06 Wb/pole, Z=175, n=1800 rpm, coverage, PFC= 0.8 A. Calculate the generated voltage B. If the load voltage is 240 V and the full load current is 100A, Calculate the armature resistance.
design a Melay sequential circuit which investigates an input sequence x and which will produce an output of z=1 whether thetotal number of 0's in the sequence is odd,provided that thesequence 01 has occured at least once.
The dielectric constant of a solid is 5. It is placed between the plates of a capacitor which are 1mm apart and which are charged to 100 V. Calculate the capacitance per square metre of this device and the local electric field acting on an atom in..
A 100 MW unit with 0.05 puturbine regulation operates in parallel with a 500 MW unit of identical turbine regulation. For a specific amount of power demand increase, find the ratio of sharing of the load by the units, system frequency is 50 Hz.
A saturated npn transistor has a base to emitter applied voltage of 0.6V. The collector to emitter voltage is 0.2V. The collector current is 12mA
A load has a 20 ohm resistor and a 4 Henry inductor connected in series. It is connected to a power source with v(t) = 100 cos(50t), connected in series to the load. What is the impedance of the load? Use phasor transform methods to obtain your an..
Given N-type silicon sample with uniform donor doping of (a) Nd= 1018/cm3 , (b) Nd= 1019/ cm3 and (c) Nd= 106/cm3, calculate the Fermi levels at room temperature assuming full ionization for all cases.
A six pole, 40 kW, 400 V d.c. motor draws 110 A from the supply. The shunt field resistance is 200 Ohm and the armature resistance is 0.5 Ohm. The armature is wave wound with 600 conductors operates at a speed of 1200 rev/min when supplying full l..
Given an analog signal with a maximum positive voltage of 3 volts and an 10-bit analog to digital converter, what will be the quantized value of an input voltage of 1.70 volts
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd