Find out the third particles speed

Assignment Help Physics
Reference no: EM1384904

Q. A tank of water 3.00m deep sits on a table 1.00 m tall. A hole is located 2.0m from the bottom of the tank. Water flows out of hole and strikes the ground. Where does it strike the ground?

Q. An unstable nucleus with a mass of 19.0 x10-27 kg initially at rest disintegrates into three particles. One of the particles, of mass 4.1 x10-27 kg, moves along the positive y-axis with a speed of 9.0 x10^6 m/s. Another particle, of mass 7.5 x10-27 kg, moves along the positive x-axis with a speed of 1.0 x10^6 m/s. (Assume that mass is conserved.)

Find out the third particle's speed.

Reference no: EM1384904

Questions Cloud

Determine fraction of the molecules : If C-1 of glucose is radioactively labeled & then enters glycolysis, which carbon of G-3-P will be labeled? Determine what fraction of the molecules will carry radioactive label?
Illustrate what is the payment term : The acceptance form, explain however, stated which full payment was due on delivery and which disputes under the contract would be settled by arbitration. Under the UCC: Do the parties have an agreement. Illustrate what is the payment term.
Discrimination and oppression case study : Kevin goes to clean out his locker after he was fired from being a manager and returns his apron and gate pass so that he may receive his final paycheck. As he goes to his locker
Single rectangular sedimentation basin : A single rectangular sedimentation basin is to be designed to treat a water flow of 1.5 MGD at the design overflow rate of 900 gpd/ ft^2.
Find out the third particles speed : A tank of water 3.00m deep sits on a table 1.00 m tall. A hole is located 2.0m from the bottom of the tank. Water flows out of hole and strikes the ground. Where does it strike the ground.
Illustrate what pricing objectiveis skimming pricing policy : Illustrate what pricing objective(s) is a skimming pricing policy most likely implementing? Is the same true for a penetration pricing policy? Which policy is probably most appropriate for each of the following products
Decentralization-moving power : The evolution of environmental management has been moving toward decentralization, moving power to the states and cities.
Estimating the steady state pm10 concentration : Estimate the steady state PM10 concentration assuming a PM10 deposition velocity of 0.12 cm/s, prevailing wind velocity of 2.5 m/s, and a constant emission flux of PM10 0.82 mg/m2-s.
What is the total internal energy of the gas : It compresses the spring, and then is pushed back in the opposite direction by the spring, eventually losing contact with the spring.

Reviews

Write a Review

Physics Questions & Answers

  How to estimate the average power output on the way up

A cylindrical container 1.60 {rm m} tall contains mercury to a certain depth, d. The rest of the cylinder is filled with water.

  Which is most possible to hurt-being stepped

A small grinding wheel has a moment of inertia of 4.0×10-5 kg m^2. What net torque must be applied to the wheel for its angular acceleration to be 160 rad s^2.

  Utilize the sine function to find out how long of a board

Assume that you need to get a heavy couch into the bed of a pickup truck. You know the bed of the truck is at the height of 1.00 and you require a ramp that makes an angle of 40 with the ground if you are to be able to push the couch.

  What is the potential energy of third charge

A point charge q1=4nC is placed at the origin, and a second point charge q2= -3nC is placed on the x-axis at x= 20 cm. A third point charge q3=2.00 nC is to be placed on the x-axis between q1 and q2.

  What is the magnitude of the static frictional force

The wheel of a car has a radius of .350 m. the engine of the car applies a torque of 295 Nxm to this wheel that does not slip against the road surface.

  What fraction of the intensity of original beam

A block of mass m = 2.00 kg is dropped from height h = 90 cm onto the spring of spring constant k = 1960 N/m. Find out the maximum distance the spring is compressed.

  Identify the three primary absorption mechanisms

In order to calibrate the strength of an Fe-55 source, many measurements of the radiation field are made with the same detector located at different distances.

  The coefficient of static friction between tires and road

A vessel whose walls are thermally insulated contains 2.5 {rm kg} of water and 0.6 {rm kg} of ice, all at a temperature of 0.0 ^circ {rm{C}}. The outlet of a tube leading from a boiler in which water is boiling at atmospheric pressure is inserted ..

  What is the average induced emf in the coil

A professor's office door is 0.9 wide, 2.0 high, and 4 thick; has a mass of 25; and pivots on frictionless hinges. A "door closer" is attached to door and top of the door frame.

  How far would it have traveled in a vacuum

A flat sheet of ice (n = 1.309) has a thickness of 1.6cm. It is on top of a flat sheet of crystalline quartz (n = 1.544) that has a thickness of 0.86cm. Light strikes the ice perpendicularly and travels through it and then through the quartz. In t..

  What are the accelerations of both masses

A 1 Kg mass on a 37 degree incline is connected to a 3 kg mass on a horizontal surface. The coefficient of kinetic friction between all surfaces is 0.10 and the pulley is frictionless and applied force is F=12N.

  Find the maximum torque on the wire

Find out the maximum torque on the wire. A bullet of mass 5g is fired horizontally into a wooden block of mass 1.26kg resting on a horizontal surface. The coefficient of kinetic friction between block and surface is 0.16.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd