Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Find out the frequency components at the output of a resonant-tuned circuit tuned at 1200 KHz with a bandwidth of 15 KHz and connected at the output of a non-linear amplifier (mixer).
A current filament carrying I in the -az direction lies along the entire positive z. At the origin, it connects to a conducting sheet that forms in xy plane. a) Find k in the conducting sheet.
Apply the classical Runge-Kutta method to solve the following initial value problem given y(0)=1 and the step size h=0.1. Verify solution using MATLAB. Plot the solutions obtained by using ode45 and dsolve. Compare the graphs and provide an explan..
1. What is the difference between discrete system and digital system. 2. What is "baseband modulation"? What types of baseband modulation are there. 3. How does time division multiplexing work? What factors affect how many channels you can transmit.
Design a BP filter using two-integrator topology. The center frequency is to be 10kHz with a bandwidth of 2kHz. Design to obtain a voltage gain of 26dB.
A 300 ohms resistor is connected across the 300 ohms antenna input of a television receiver. The bandwidth of the receiver is 6 MHz, and the resistor is at room temperature (20' C). Find the noise power and noise voltage applied to the receiver in..
An alarm is powered by 120 VAC, and the on/off state of the alarm is controlled by an EM relay. Design the interface between a computer output port and the EM relay. The dropout voltage is 3.5 V, and the coil current needs
Design a regulated DC power supply. You will have for input a 110 V input source at a frequency of 60 Hz. The Zener diode to use is the 1N4733A (which is available in the lab). The output voltage is to be 5.1 V with a load resistance above 2.2K.
Suppose it is known that an analog signal varies between -3V and + 3V, but we require the range of this signal to be changed so that it varies from 0 to 5V in order to meet the input range of an analog/digital converter circuit.
design a resonance circuit with following specifications: L = 10 mH, RL = 4W, Imax = 200 mA, fs = 10kHz, Q = 20. That is, determine the required R, C, and supply Voltage E. For R and C, use the closest standard values.
A modulating signal is amplified by a 80% efficiency amplifier before being combined with a 20 kW carrier to generate an AM signal. what would be The required DC input power to the amplifier, for the system to operate at 100% modulation.
The power factor of a load connected to a 120-V 60-Hz source is raised from 0.866 lagging to 0.966 leading by connecting a 110.5-F capacitor in parallel with the load. Determine the load current I1 and the circuit current IT
Two single phase transformers are connected in parallel with the following parameters. Transformer A, rated at 60 kVA Rc=250 k Ohm Req=25 Ohm Xm=45 k Ohm Xeq=150 Ohm
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd