Find how high does the listener need to mount the anntena

Assignment Help Electrical Engineering
Reference no: EM13258815

a high power FM station of frequency 96.9 MHz has an antenna height of 1200 feet. If the signal is to be recieved 60 miles from the station, how high does the listener need to mount their anntena in this fringe area?

Reference no: EM13258815

Questions Cloud

Discuss how monetary and fiscal policy : Discuss how monetary and fiscal policy could have been better leveraged to avoid the recession in the early 2000s. discuss how supply and demand would be affected under each of the four degrees of competition . give specific examples to support yo..
What is the current price of the stock : what is the current price of the stock? b) how much is the PVGO ( pesent value of growth opportunity) if the expected long-run dividend growth rate is 8 percent?
What is the frequency at which the gain magnitude is unity : use an ideal op amp to design an inverting integrator with an input ressistanceof 10 kilo ohm and an integration time constant of 10^-3. What is the gain magnitude and phase angle of this circuit at 10rad/sand 1rad/s.
Find a company can produce a product : You are a consultant called in to estimate the costs after the employees learn how to do a job more efficiently by repetition of new product.
Find how high does the listener need to mount the anntena : a high power FM station of frequency 96.9 MHz has an antenna height of 1200 feet. If the signal is to be recieved 60 miles from the station, how high does the listener need to mount their anntena in this fringe area
What is the price of the bonds : Renfro Rentals has issued bonds that have a 11% coupon rate, payable semiannually. The bonds mature in 6 years, have a face value of $1,000, and a yield to maturity of 9%. What is the price of the bonds? Round your answer to the nearest cent.
Prepare cost of goods sold statement from the information : The information relating to cost department of ALPHA& OMEGA Corporation is as follows. Prepare Cost of Goods Sold Statement from the abovein formation.
Why did reconstruction end : Why did Reconstruction end? Answer Black issues became secondary to other national priorities and interests. Financial panic and economic hard times distracted northerners. Southern white Democratic violence halted black political control. All of ..
What voltage amd power gain expected with the load connected : an amplifier with 40dB of small signal , open circuit voltage gain ,an input resistance of 1 Mega ohm , and an output resistance of 10 ohm , drives a load of100 ohm. What voltage amd power gain (expressed in dB) would u expect with the load connec..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the sending-end voltage for load factor of leading

A 30-km, 34.5-kV, 60-Hz three-phase line has a positive-sequence series impedance z = 0.19 + j0.34 ?/km. The load at the receiving end absorbs 10 MVA at 33 kV. Assuming a short line, calculate: (a) ABCD parameters,

  What are two fundamental advances

what are two fundamental advances in the circuit theory that were developed in the 19th century in response to the challenges of telegraphy?

  Find approximate saturated synchronous reactance at current

A 25MVA, three phase, 13.5kV, Y-connected, two pole, 60Hz synchronous generator was tested by the open circuit test and short circuit test and tabulated in table 1. If the armature resistance is 0.24 ohms per phase.

  What is the half-power compressed-pulse width

Gaussian weighting following ideal, unweighted equalization is used to reduce time sidelobes seen with a 250-MHz chirp-pulse-compression radar. Rectangular chirp pulses are transmitted. (a) What is the half-power compressed-pulse

  Explain comunication technology

When a square wave with a fundamental frequency of 2khz and amplitude 5v and comprised of up to five odd harmonic (each successive odd harmonic having half the amplitude of its predecessor) is passed though a standard telephone line of bandwidth o..

  Determine the maximum and minimum spectral frequencies

Determine the maximum and minimum spectral frequencies received from a stationary GSM transmitter that has a center frequency of exactly 1950.000000 MHzassuming that the receiver is traveling at speeds of.

  What is the separation distance of the sources at the height

The thickness variation must be within ±10% across the substrate. Your evaporation chamber consists of two sources separated by a distance D and the substrate is at a height h from the sources.

  What is the system reliability of a system comprised

The reliability performance of each microprocessor is based on the exponential reliability distribution with the following failure rates: A = 23.5 × 10^-3 , B = 12.5 × 10^-4 , C = 12.5 × 10^-4 and D = 23.5 × 10^-3

  Define design bandpass filter of ''sallen and key'' topology

Design a bandpass filter of 'Sallen and Key' topology and having the following characteristics fo = 3.3 kHz, Q = 2.2

  Which one will store most charge

For a circuit with resistor of 10 K ohm and a capacitor of 5 micro Farads, what is the time constant in second?

  What should be the series resistance that should be added

Assuming the input resistance of the load cell is 420  and rated output is 3.0mV/V at the rated capacity. What should be the series resistance that should be added to the excitation side so that the output voltage I reduced to 2.0mV/V

  Determine appropriate vectors and switching times

The balanced 60Hz waveform sample that we must modulate is the point where t=4.4ms. The DC voltage from rail to rail is 300V. assume the q axis and a axis are in same direction. The use of mathCAD is recommended.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd