Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A line of charge with uniform density of 10 microC/m exists in air along z-axis between z=0 and z=10 cms . Find Electric Field Intensity on p1(0, .1, 0)
2) A device that responds to a small current or voltage change by activating a mechanical switch allowing a larger amount of current flow is 3) Where does a program transfer to when an interrupt occurs Interrupt vector table Interrupt service ro..
In a binary digital communications systems, the bit energy required at the receiver input terminals is 50x10^-18 JOther parameters are as follows: Gt(dB)=24 dB Gr(dB)= 26 dB f= 10GHZ d=40,000 km
If a transformer has a turns ratio of 1:5 and a primary voltage of 20 V AC, what will the secondary voltage be?
Determine if the following CT signal is periodic. calculate the fundamental period T0 for the CT signal: x(t) = 2cos(4*pi*t/5)*sin^2(16t/3)
The angle of departure is defined as 180 degrees plus the phase angle of GH computed at the complex pole, but ignoring the contribution of that particular pole.
The laminated silicon steel core of a transformer has a mean length of 0.06 m and a cross section of 0.005 meter square. there are 150 turns on primary winding and 450 turns on the secondary. the input is 200 V rms at 50 Hz.
Pulse width modulation (PWM) is used to control dc voltage to an electric heater. The supply voltage is 12 Vdc, and the heating element is modeled as a 1 resistance. (a) Calculate the average power delivered to the heater when the voltage is switche..
The basic column control system shown in Figure is somewhat more complicated than the basic neutralizer control system
b) What are the equilibrium electron and hole concentrations at 300K and 500K (hint: You will have to find Nc and Nv at 500K, but it isnt necessary for 300K) c) Why does the mobile carrier concentration increase at high temperatures
Three towns A, B & C are situated at the corners of an equivalent triangle of side 30 km. It is proposed to supply power to extent of 30 MW, 10 MW, 20 MW to A, B & C respectively from one substation. Where should substation be located to minimize ..
Semiconductor A is direct band gap and semiconductor B is indirect gap. For providing same short circuit current density of a solar cell, which material will need more thickness
Two delta-connvected loads are connected in parallel and powered by a balanced Y-connected system. The small of the two loads draws 10k VA at a lagging Power Factor (PF) of 0.75, and the larger draws 25k VA at a leading PF of 0.80.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd