Find bandwidth at which the snr on the ground is 10 db

Assignment Help Electrical Engineering
Reference no: EM13288724

Synchronous Satellite Link: Consider a 2 GHz link between asynchronous satellite and a ground station on the equator. The bandwidth of the up-link and down-link are the same. The orbital radius of the satellite is 36,000 Km and the radius of the Earth is6,400 Km. The satellite antenna beam must just cover the wholeEarth; its transmitted power is 100 w; and its receiver noisetemperature is 300K (because the antenna is looking at the warmEarth). The ground station antenna diameter is 64 cm; its aperture efficiency is 100%; and its receiver noise temperature is 50 K(because it is looking at the cold sky). Note that RF power isusually specified in dB with respect to a reference. The most common reference is 1 mw, which gives rise to the power unit ofdBm. For example -30 dBm is 1 microwatt.

Find: (a) the beam solid angle of the satellite antenna;

(b) the gain of the satellite antenna in dB;

(c) the power received on theground in dBm;

(d) the bandwidth at which the SNR on the ground is10 dB; and

(e) the power that must be transmitted from the ground(in dBm) so the uplink channel capacity will be the same as that ofthe down link. The channel capacity C =BW*log2(1+SNR).

Reference no: EM13288724

Questions Cloud

Explain 3-dimethylpentane and including stereoisomers : Draw all possible monochlorination products of 3,3-dimethylpentane, including stereoisomers.
Determine the work done on the object : An object moves 2.90m in the + x- direction under the influence of a 148 N force directed 42 degrees above the x-axis. Find the work done on the object
Explain how many moles of sodium bicarbonate : How many moles of sodium bicarbonate are contained in 10mL of a 10% aqueous solution
How much work did gravity do on the ball : If Galileo dropped a 2.37 kg cannon ball from the 58.5m Tower of Pisa, how much work did gravity do on the ball
Find bandwidth at which the snr on the ground is 10 db : Synchronous Satellite Link: Consider a 2 GHz link between asynchronous satellite and a ground station on the equator. The bandwidth of the up-link and down-link are the same. The orbital radius of the satellite is 36,000 Km and the radius of the E..
What is the charge of the central particle : Flux and nonconducting shells. A charged particle is suspended at the center of two concentric spherical shells that are very thin , What is the charge of the central particle
What does that imply about the rate of return : Time value Jim Nance has been offered an investment that will pay him $500 three years from today.
Explain a would be removed by four successive extractions : what weight of A would be removed from a solution of 10g of A in 100mL of water by a single extraction of 100mL lingroin. what weight of A would be removed by four successive extractions with 25mL portions of lingroin
Find the potential energy of the system prior to release : A slingshot consists of a rubber strap attached to a y-shaped frame, with a small pouch at the center of the strap to hold a rock or other small projectile. FIND the potential energy of the system prior to release

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the scalar magnitude on lead one

An ECG has a scalar magnitude of 1 mV on lead II and a scalar magnitude of 0.5 mV on lead III. Calculate the scalar magnitude on lead I.

  Determine the phase angle difference in voltage and current

Determine the phase angle difference between the voltage and current, and whether the voltage leads or lags the current, if (a) V = 240/243 V rms and I = 3/9 A rms; (b) the power factor of the load is 0.55 lagging; (c) the power factor of the load..

  Determine what will be carrier frequency variation

A 5-volt intelligence amplitude causes the frequency to change to ± 25 kHz. What will be the carrier frequency variation corresponding to an intelligence amplitude of 10 volts

  What is the magnetization and what is the magnetic feild

A toroid is fille with liquid oxygen that has a magnetic susceptibility of 4*10^-3. The toroid has 2000 turns and carries a current of 15 A. Its mean radius is 20 cm, and the radius of its cross section is 8 mm. (a) What is the magnetization

  Determine r-l-g and c for the line

A lossy transmission line at 1GHz has the following characteristics: Z0= 50.0 ohms alpha= 0.01 dB/m, Betta=8 rad/m. Determine R, L, G and C for the line

  How the angle of the incident light affected

Discuss how the angle of the incident light affected the solar cell? How could solar cell designs and/or installations be designed to counter this affect?

  To what value should the 2 a source be changed to reduce vx

(a) Using superposition, determine the voltage labeled vx in the circuit represented. (b) To what value should the 2 A source be changed to reduce vx by 10% (c) Verify your answers by performing three dc sweeps in PSpice.

  Determine acceleration of the proton when it has a velocity

a proton moves through a region containing a uniform electric field given by E=50.0 v/m and a uniform magnetic field B=(0.200+.300+.400)T. Determine the acceleration of the proton when it has a velocity v=10.0m/s

  Which system ratio of bit energy to one-sided noise density

Assume a binary PCM system in which the system ratio of the bit energy to the one-sided noise density at the receiver input is 10 dB. Assume that the probability of error for any value of the independent variable off the scale can be approximated ..

  What will the cound be after seven clock pulses

1. A MOD 8 down-counter is holding the count 101 (base-2). What will the cound be after seven clock pulses 2. A MOD 5 and a MOD 20 counter are cascaded. What is the output frequency if the input frequency is 60MHz

  How to match network by placing an appropriate reactance

A certain three-port network is lossless and reciprocal, and has S13 = S23 and S11 = S22. Show that if port 2 is terminated with a matched load, then port 1 can be matched by placing an appropriate reactance at port 3.

  For what confidence level would the claim be valid

A supplier claims that a transistor has a current gain of 100. 15 transistors are measured, and are found to have a sample mean of 99.5 and a standard deviation of the sample mean 2. a) For what confidence level would the claim be valid

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd