Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1) Consider the circuit shown below, initial energy storage is zero.
a) Find the transfer function of this circuit, the input is the voltage source, the output is the voltage across the capacitor.
b) Find and plot the poles and zeros of the transfer function.
c) Let the voltage source be vg = 50 t u(t), use the transfer function to find vo.
d) Identify the transient response.
e) Identify the steady state response.
2) Find the convolution of the following signals.
design a circuit to limit the output voltage between -5v and+5v. the input is a sinusoidal source with a peak value of 10 v and a frequency of 1KHz.
There is a generator with internal resistance, 50 Ohms. A matching load of 50 Ohms is connected for max power to be extracted. There exists 2 other resistors which do not equal to 50 Ohms; one resistor is small, one resistor is big.
Find the stall current, max speed in rotations per minute (RPM), and armature current at a speed of 480.769 radian/s (4591.006 RPM). Discuss the relationship (if any) between the armature current at max speed
Assuming there is no power constraint on the users, give an approximate expression for the achievable spectral efficiency (bits/s/Hz) to support N users for a given outage probability pout and cb/I0 requirement /3 for each user.
if we have a signal source impedance that is almost as high as the input impedance of the inverting Op Amp (Rin) what effect would that have. How much signal would appear at the inverting input of the Op Amp.
A burst of 8^14 electrons accelerated to an energy of 12 MeV per electron is stopped in a copper target block of mass 180 g. If the block is thermally insulated, what is its temperature rise
The designer selects RD=2RL. If its required to realizes an overall voltage gain Gv of -10 V/V, what gm is needed Also Specify the bias current ID. If to increase the output swing, RD is reduced to RD =RL, what does Gv become
What is the expected return for a that has $200 in stock A with an expected return of 15%, $300 in stock B with an expected return of 10%, and $500 in stock C with an expected return of 25%?
Describe the characteristics of the series RC filter circuit with the output across the resistive component. Distinguish the pass and stop bands with reference to the cutoff frequency. Also, state what happens to the circuit complex impedance at t..
A Gaussian source with mean zero and variance 1 is to be transmitted via a channel that can provide a transmission capacity of 1 bit per each source output. a) what is the minimum mean-squared-error achievable
A linear-phase FIR filter should be designed with the ideal magnitude response shown in Figure 1 which represents an narrow band-pass filter. The lower cutoff frequency, fL , is 2,000 Hz, and higher cutoff frequency, fH , is 3,600 Hz.
Derive the simplest sum-of-products expression for the function f(x1, x2, x3, x4, x5) = x1'x3'x5' + x1'x3'x4' + x1'x4x5 + x1x2'x3'x5. (hint: use the consensus property- xy + yz + x'z = xy+ x'z.)
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd