Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Two line charges are located at x=+or-,y=0. Find an expression for the potential at any point (x, y), assuming zero volts on the z-axis. When calculating the potential, you may start with the potential of a single infinite line charge, assume a reference point on the z-axis, and use superposition.
A single-phase 50-KVA, 2400/240-volt, 60-Hz distribution transformer has a 1-ohm equivalent leakage reactance and a 5000-ohm magnetizing reactance referred to the high-voltage side. If rated voltage is applied to the high-voltage winding
The other branch is an inductor with reactance of 8 ohms. If an external load is to be placed across the current phasor source, find the Thevenin source equivalent of the circuit described. Draw the original circuit and the Thevenin equivalent cir..
An Amplifier hasa low pass STC frequency response. the magnitude of the gain is 20dB at dc and 0dB at 100KHz. What is the Corner frequency At what frequency is the gain 19dB At what frequency is the phase -6degrees
A modulating signal consists of two sinusoidal components: 1 kHz and 3 kHz. The transmitter carrier frequency is 80 kHz. Assume in a SSB-USB modulated signal that the inserted carrier at the receiver is 200 Hz too high.
Design a square wave generator that will provide a 4kHz square wave with a positive peak vlaue of +10V and negative peak value of -10V. You may use any number of op amps, resistors, and capacitors in this design.
Design a 4-element broadside array with equal side lobe level of -20 dB relative to the peak value , take the inter-element spacing d=λ/2 , find the resulting beamwidth to null.
Find the surge impedance load and based on the practical line loadability determine the number of three phase,60 Hz lines required to transmit this power, with one line out of service.
Given a DSP system in which a sampling rate of 8000 Hertz is used and the antialiasing filter is a second order Butterworth low pass filter with a cutoff frequency of 3.2 KHz determine a. The percentage of aliasing level at cutoff frequency
A single, common-anode, 7-segment LED is connected to the Arduino Connector J1 through current-limiting resistors. The diagram in Figure 1 shows the mapping of the pins of the connector to the pins of the 7-segment.
In a vessel with a volume 3 m3 you put 0.03 m3 of liquid water and 2.97 m3 of water vapor so that the pressure is 101.33 kPa. Then you heat the system until all liquid water just evaporates. What is the pressure and temperature in the vessel at th..
It is given that the energy consumed by a computer system is (100 Joules/sec^2)*t^2 Joules during the first second after being activated at t=0. What is the average power dissipation during this time
A linear-phase FIR filter should be designed with the ideal magnitude response shown in the following figure. The lower cutoff frequency, fL , is 1,200 Hz, and higher cutoff frequency, fH , is 2,200 Hz. Sampling frequency fS = 8,000 Hz.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd