Explain why the scc is linear

Assignment Help Electrical Engineering
Reference no: EM131265532

1. Explain why the SCC is linear.

2. Distinguish between Xs (unsaturated) and Xx (saturated). Which one should be used for higher accuracy in predicting the voltage regulation of a synchronous generator.

3. The synchronous reactance of an alternator is not constant over the entire operating range. What is this so? What value would you use?

4. In what manner does an synchronous motor adjust itself to an increasing shaft load?

5. State the assumptions made in the Potier method and the effect they have on the accuracy of voltage regulation as calculated by this method.

Reference no: EM131265532

Questions Cloud

What conditions determine the instant of synchronization : Explain briefly the process of synchronizing a synchronous motor to the bus-bars. What conditions determine the instant of synchronization?
Who has brought the charges against socrates : Socrates claims that he has always had within him a divine voice which sometimes stops him from saying or doing something, but never urges him to do anything. Why does he think the voice has usually stopped him from participating directly in the p..
Identify two factors that influenced the early development : Identify at least two factors that influenced the early development of the different philosophical perspectives of learning, and identify at least two factors that are currently influencing curriculum design.
How can the speed of an synchronous motor be varied : In what operating condition is a synchronous motor referred to as a synchronous condenser? How is this condition achieved?
Explain why the scc is linear : The synchronous reactance of an alternator is not constant over the entire operating range. What is this so? What value would you use?
What propose to effect positive change relative to problem : How you view a problem and what you propose to effect positive change relative to the problem is closely related to your experiences and to your professional role.
Economic impact of integrated delivery systems : What is the economic impact of integrated delivery systems (IDS) and how can IDS improve economic outcomes for the U.S. healthcare delivery system? Provide examples to support your findings.
Discuss both advantages and disadvantages of your proposal : Discuss both the advantages and disadvantages of your proposal. Last, your document will focus on costs and the time frame needed to implement your decision.
Is this using the lyric or lysogenic cycle : The question is: Using the box on page 374(11th) about influenza, describe the processes involved in the creation of the 2009 H1N1 strain of virus. Is this using the lyric or lysogenic cycle

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Can the zener diode be used as a conventional diode

can the zener diode be used as a conventional diode? explain your answer and verify with a curve from the curve

  Evaluate the reading on the power meter in watts

The show output of an AM transmitter is connected to a spectrum analyzer (calibrated in dBm) and a broadband Power Meter calibrated in Watts. If the spectrum analyzer show is below.

  Find the pun as a dual of the pdn in complete realization

(a) Give the Boolean function Y . (b) Sketch a PDN directly from the expression for Y. Note that it requires 12 transistors in addition to those in the inverters (c) From inspection of the PDN circuit, reduce the number of transistors to 10

  Estimate specific fuel consumption and overall efficiency

A diesel power station has the following data : - Estimate specific fuel consumption, overall efficiency, and thermal efficiency of engine.

  Determine the error in temperature reading if noise is added

A temperature sensor produces 10 mV for each degree Fahrenheit. Determine the error in temperature reading if 20 mV of noise is added to the sensor output signal when the temperature is 70 degrees.

  Find how high does the ball rise in units of meters

As the ball rises, it gradually loses kinetic energy as its potential energy increases. At the top of its flight, when its vertical speed goes to zero, all of the kinetic energy has been converted into potential energy.

  What would happen to the charge after it crosses resistors

a power source is giving 12 V to a circuit. In the circuit there is a resistor. Therefore, would the voltage drop 12 V when the charge moves across the resistor making there 0 V in the circuit after the resistor.

  Calculate the net radiation heat transfer from the cavity

Consider a cylindrical cavity of diameter D=100 mm and depth L=50 mm whose sidewall and bottom are diffuse and gray with an emissivity of .6 and are at a uniform temperature of 1500 K. The top of the cavity is open and exposed to surrounding that ..

  Determine the primary current when both loads are connected

A 240/40 volt transformer supplies two different secondary loads. One load (a) draws a current of 12 amperes at a lagging power factor of 0.94. The other load (b) draws a current of 12 amperes at a leading power factor of 0.94.

  Find the maximum phase deviation for the signal

Consider an angle-modulated signal xc(t) = 10 cos{(10^8)pi t + 5sin 2pi(10^3)t}. Find the maximum phase deviation. Find the maximum frequency deviation.

  Find the annual electrical charges

Find the annual electrical charges if the tariff is Rs 60 per kVA of maximum demand per annum plus 5 paise per kWh ; assuming the load to be steady for 2000 hours in a year.

  Design an adder that computes the sum of four 8-bit numbers

Design an adder that computes the sum of four 8-bit numbers, using 8-bit carryripple adders. Use a basic 8-bit carry-ripple adder as a building block for the design.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd