Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Sampling and gausssian distributionAssume, I have a Gaussian Distribution given by N~(u0,var) where u0 is mean and var is variance by sampling 999 points.
Maximum Likelihood to get the above parameters i.e. u0 and var.
Now from these 999 points, I take one point out (lets call it i) and add a new point (lets call it j). What will the new mean and variance be?
Do either or both of the reasons you gave in part (a) above also apply to a point to point voice link using frequency modulation? c. Which parameter of an FM transmission determines whether it is wideband or narrow band?
Maximum Amount of Channels A Link Can Carry, A microwave radio link operates over a bandwidth of 400 MHz at C band. The link carries a number of channels of data using FDMA.
Detailed Explanation to Op-Amp, A certain op-amp has an open-loop voltage gain of 100,000 and a common mode gain of 0.2. Determine the CMRR in dB.
In a typical mobile communications base station (or cell site), a radio frequency (RF) signal is amplified in the base station and then sent (over cable) to the antennas at the top of the tower.
Finding the periodicity in N of the discrete time signal x(n) = Cos(3pi*Ts.n + pi/4) and then plotting the discrete signal. From this the condition on the sampling period is determined
Need for radical future plans to alleviate the very real problem we are faced with in New Zealand and address this problem, by providing an answer to Transpower
Characteristics of a filter, A filter has the following characteristics: Attenuation = 3.0 dB from 0 Hz to 2 kHz. From 2 kHz to 20 kHz attenuation increases from 3 dB to 23 dB in a straight line when plotted on axes of power in decibels (vertical a..
This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.
You have to figure out which one using cross or auto correlation.
A pulse width modulation (PWM) circuit works by varying the duty cycle of the square wave while keeping the period fixed.
And how long it will take to reach that temperature assuming no heat lost in the process and comments on your results and may research the properties of nichrom wire to determine the resistivity of the wire
Determine the Laplace transform of the above signals (use properties of the Laplace transform) including the corresponding region of convergence.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd