Explain the graph we recieved in the simulation that

Assignment Help Electrical Engineering
Reference no: EM13346234

Explain the graph we recieved in the simulation that shows the relationship between the recieved (throughput)and sent (load) packets. why does the throughput drop when thw load is either very low or very high?

Reference no: EM13346234

Questions Cloud

Calculate the molality of c2h5oh in a water solution that : calculate the molality of c2h5oh in a water solution that is prepared by mixing 50.0ml of c2h5oh with 100.0 ml of h2o
When luminaires lighting fixtures are installed in : when luminaires lighting fixtures are installed in clothes closets a distans of in. millimeters must be mauntained
Suppose 532 ml of neon gas at 20c and 104 atmospheres and : suppose 532 ml of neon gas at 20c and 1.04 atmospheres and 376 ml of sf6 gas at 20c and 0.97 atmospheres are put into a
The piston is moved to increase the volume to 600 l which : a gas is enclosed in a cylinder fitted with a piston. the volume of the gas is 2.00 l at 1.00 atm pressure. the piston
Explain the graph we recieved in the simulation that : explain the graph we recieved in the simulation that shows the relationship between the recieved throughputand sent
If i initially have a gas at a pressure of 12 atm a volume : if i initially have a gas at a pressure of 12 atm a volume of 23 liters and a temperature of 200 k and then i raise the
Explain the graph we recieved in the simulation that : explain the graph we recieved in the simulation that shows the relationship between the recieved throughputand sent
Determine the smallest horizontal force required to pull : determine the smallest horizontal force required to pull out wedge a. the crate has a weight of 200 and the coefficient
What are the advantages and disadvantages of recycling : what are the advantages and disadvantages of recycling

Reviews

Write a Review

Electrical Engineering Questions & Answers

  From which circuit is the recovered modulating signal taken

The FM input to a PLL demodulator has an unmodulated center frequency of 10.7 MHZ. (a) To what frequency must the VCO be set (b) From which circuit is the recovered modulating signal taken

  Find the phasing of the element in order to rotate direction

A 4-element unform linear array with interelement spacing of λ/2 is operated as a broadside array , find the beamwidth betwen nulls and the side lobe level in dB . find the phasing of the elements in order to rotate the direction

  Sketch the load line and plot the q- point

The current in the bias resistors should be no more than 10 percent of the drain current- Determine VGS, ID, and VDs. Sketch the load line and plot the Q- point.

  Write the equation for the acceleration

Write the equation for the acceleration as a function of the position change of the platform.

  Write a 4-bit up counter with an asynchronous clear

Write a 4-bit up counter. Your counter has a asynchronous clear and when the clear is activated, the counter is reset to 3. The count range is from 3 to 9.

  Find the ratio between the power delivered to the same motor

However, for short-time operation, a delta connection can be used at the nominal wye voltage. Find the ratio between the power delivered to the same motor in the wye and delta connections.

  Verify the claim to prove or disprove the assertion

A friend of yours claims that the output of any LTI system corresponding to the input x(-t) is y(-t), i.e., time-reversal of input results in time-reversal at the output. Verify this claim,i.e., prove or disprove the assertion.

  What is the angle of incidence between the sun and the array

A house at 42 degree north latitude has a roof that faces due south, and is elevated to an angle of 23 degree. A solar panel is mounted to the roof. what is the angle of incidence between the sun and the array at 10 am on May 5th

  Calculate full-load current and amount of capacitive kvar

1. Calculate the total (composite) load power factor, true power, reactive power and apparent power. 2. Also calculate the full-load current and the amount of capacitive KVAR needed to bring the overall power factor to .95 lagging.

  Describe why there is no earthing in television

why there is no earthing in television, rather it is a very complicated and its plug is always 2 pin. On the other hand mobile charger has got 3 pin plug and therefore earthing is done in it while charging of mobile.

  Determine the force density and magnetic flux

A current density J¯ = ˆy sin(2x) A/m^2 is subject to a z-directed magnetic field H¯ = ˆz10 A/m. a. Assuming the vacuum permeability (i.e. a non-magnetic medium), what is the magnetic flux

  Determine the force per unit length on the conductor

A current sheet with K = 10a A/m lies in free space in the z = 2m plane. A filamentary conductor on the x-axis carries a current of 2,5 A in the a direction. Determine the force per unit length on the conductor.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd