Explain resisitive load

Assignment Help Electrical Engineering
Reference no: EM13140235

Resisitive load
A 4:1 step down transformer uses a 60Vac source on the primary windings. There is 120mA flowing through the load resisitance on the secondary windings. What is the resisitive load? Is it 125 ohms? 15V/.120=125

Reference no: EM13140235

Questions Cloud

Define zener diode : Zener diode, Can You show me how to solve the following: If a 5k resitor is connected between the cathode of a 6.2V ZENER diode and a 12V power supply.
What is the best measure of central tendency for data : However one of the children fails to solve the peoblems, so the researcher has an undetermined score. what is the best measure of central tendency for these data?
Basic organizational methods for comparison and contrast. : Explain the key differences between the two basic organizational methods for comparison and contrast.
Reasonable cost of capital : Suppose ARG Inc. estimate its cost of capital (WACC) for the year 2010 to be 12%, should the project officer used this WACC to evaluate all of its potential projects even if they vary in risk? If not, what is a reasonable cost of capital if the fi..
Explain resisitive load : Resisitive load, A 4:1 step down transformer uses a 60Vac source on the primary windings.
Explain dividing line between safe and unsafe water : Would you recommend test- ing H0 : m = 5 versus Ha : m> 5 or H0 : m= 5 versus Ha : m
Describe one erikson''s developmental theory : briefly describe one erikson's developmental theory
What is the value of the unknown equilibrium constant : Given the information below, what is the value of the unknown equilibrium constant?
Specific circumstances : Based on your comparison in Part A, advise Liam, Nisha, Saul and Jing which business structure is most appropriate given the specific circumstances of the Bio Breads operations as set out above. In your answer you must give reasons for your advice.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define what is the fm improvement in db

What is the peak frequency deviation of the FM signal? What is the FM improvement in dB?

  Define a block error detecting code has a minimum distance

A block error detecting code has a minimum distance of three. How many errors can this code detect and how many can it correct

  Define design bandpass filter of ''sallen and key'' topology

Design a bandpass filter of 'Sallen and Key' topology and having the following characteristics fo = 3.3 kHz, Q = 2.2

  Design an rc-low pass filter

Design an RC-Low Pass Filter with cutoff frequency at fc=0.5GHz and plot its frequency response and design a parallel resonance circuit with resonance frequency of 30kHz and bandwidth of 20kHz and plot its frequency response.

  Why can''t a video signal such as an ntsc analog television

Why can't a video signal such as an NTSC analog television signal be transmitted over a two km length of loaded twisted pair cable with a frequency range 300 Hz to 3,400 Hz? What is the bandwidth occupied by an NTSC video signal?

  Differential amplifier with thermocouple

What are the essential features of an ideal op amp? Identify the terminals of an op amp. Draw its equivalent circuit. Define virtual ground and what is difference amplifier? Draw its circuit. Define C.M.R.R.

  Explain the critical radius of insulation.

Explain the following terms; (i) critical radius of insulation. (ii) economic lagging thickness.

  Explain capacitance of parallel plates capacitor

Explain Capacitance of parallel plates capacitor, Relative permitivity is 500, The area is one square meter, The distance between the plates is 0.001 meters

  Explain the operation of sequential logic devices

Explain the operation of sequential logic devices and evaluate the output waveform in relation to the clock for QA, QB and QC in the subsequent circuit and show the binary sequence represented by these waveforms

  Explain what is the input impedance

If we have a 600ohm transmission line terminated with a 1200ohm resistor, how long must the transmission line be if the input impedance is purely real?

  Hhow many voice channels are carried by a transmission

How many voice channels are carried by a E1 transmission given 8 kHz sampling and 8 bit words? Why is an end of frame marker always required in a digital telephony system?

  Define addition of two numbers in ieee 754 format

Addition of two numbers in IEEE 754 format A) a=3f200000, b=be600000 B) a=3f200000, b=ff800000 C) a=01100000, b=80e00000

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd