Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Explain methods FOR artificial aggregate productions : 1. Cold-bonding method (EXPLAIN detailed) 2. Sintering Method (EXPLAIN detailed) 3. Autoclaving Method (EXPLAIN detailed)
Steam at 3.45 MPa, 260oC enters a well-insulated valve operating at steady state with a mass flow rate of 0.05 kg/s through a 2.54 cm diameter pipe. The steam expands to 1.40 MPa with no significant change in elevation.
A 85F capacitor is charged by a constant current source, and its voltage is increased to 6 V in 7 s. Find the value of the constant current source, Is, and the energy stored in the capacitor after 7 s.
a single phase 10kVA, 2400/120 V transformer has the following equivalent measurements (referenced to high side): Rc 64k ohms, Xm 9.6k ohms, Re 19.3 ohms, Xe 73.3 ohms. if the secondary load is Zl = 5 angle 30 degrees ohms
Design the circuit such that IDQ = 0.25 mA and VD = -2 V. The nominal transistor parameters are VTP = -1.2 V, K'p, = 35 μA/V2 and viL = 15. Sketch the load line and plot the Q-point.
(a) Design a high-pass filter with a cutoff frequency of 40 kHz. Use 0.01 uF capacitor and an appropriate resistor. B) Sketch and label the circuit. C) What is the gain of the filter at the cutoff frequency Give your answer both as ratio (Vout/Vin..
How to control one lamp from six different places by using two, 2-way switches and four intermediate switches. ?
A germanium wafer is doped with phosphurus Nd=10^15 cm^-3. Find the electrons and holes densities and the Fermi level at room temperature.
A Wheatstone bridge circuit has resistance arms of 400, 40, 602, and 6000 ohms taken sequentially around the bridge. The galvanometer has a resistance of 110 ohms and is connected between the junction of the 40- and 602-ohm resistors
If L=0.0053nH, C=15µF find the operating frequency of series LC circuit. What factors decides capacitance? Explain using diagram.
An OpAMP has a unity gain frequency (ft) of 10MHz and a slew rate of 10V/us and AVoc = 120dB at DC (f=0). Assume VCC = -VEE = 15 Volts.a. Approximate the cutoff frequency of the OPAMP itself. b.
Once INIT is negated, Z should remain 0 until X has been 0 for two successive ticks and 1 for two successive ticks, regardless of the order of occurrence. Then Z should go to 1 and remain 1 until INIT is asserted again.
A direct current source is required to supply a controlled current of 20A to a load in which the resistance varies from 0 to 12 ?. The source consists of a 208 V(L-L) , 60 Hz , there -phases , a controlled bridge rectifier, and a large series indu..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd