Explain looking at feedback and some opamp problems

Assignment Help Electrical Engineering
Reference no: EM13139059

Looking at feedback and some Opamp problems
1. If the unity gain frequency is 5 MHz and the midband open-loop voltage gain is 200,000, what is the cutoff frequency?

2. An op amp has a voltage gain of 500,000. If the output voltage is 1V, what is the input voltage?

3. Name a few ICs other than op amps.

4. Above the cutoff frequency, what happens to the voltage gain of the 741C?

5. Describe some of the characteristics of the 741C.

Though in some applications the 741 is a good approximation to an ideal op-amp, there are some practical limitations to the device in exacting applications.

* The input bias current is about 80 nA.
* The input offset current is about 10 nA.
* The input impedance is about 2 Mega Ohms.
* The common mode voltage should be within +/-12V for +/-15V supply.
* The output impedance is about 75 Ohms.
* The voltage gain rolls off 6dB per octave starting at 100kHz.
* There is a finite input offset which must be zeroed by a resistor between pins 1 and 5. The input offset is typically 2mV to <6mV.
* The slew rate is 0.5V/microsecond.
* There is some temperature dependence.

Reference no: EM13139059

Questions Cloud

Probability that fewer accidents with teenager behind wheel : If the politician is correct, what is the chance that you would observe 9 or fewer accidents with a teenager behind the wheel?
Alleging breach of contract : Three months later, after Smith & Jones has continued performing under the contract, the E-Business board of directors tells the accountants that it is canceling their contract. Smith & Jones files a suit against Dan and E-Business, alleging breac..
What is the percent yield of a reaction : What is the percent yield of a reaction in which 274 g phosphorus trichloride reacts with excess water to form aqueous phosphorus acid (H3PO3) and 105 g HCl?
What is the effect of each of these items : Partner A performs $5,000 of contract-type Code Sec. 707(a) services for the ABC partnership in December of 2009, but does not get paid until January of 2010. A and ABC are both calendar-year taxpayers, but A is on the cash basis and ABC is on the..
Explain looking at feedback and some opamp problems : Looking at feedback and some Opamp problems, If the unity gain frequency is 5 MHz and the midband open-loop voltage gain is 200,000, what is the cutoff frequency?
Basics of overall net operating income : Fixed expenses charged to the department are $65,000 per year. It is estimated that $40,000 of these fixed expenses could be eliminated if the department is discontinued. These data indicate that if the department is discontinued, the company's ov..
What do you think about a curse and a blessing by milena : what do you think about a curse and a blessing by milena ateyea
Existentialism by soren kierkegaard : Soren Kierkegaard claimed that all truth (in particular, religious truth) is subjective, inward, and immediate, not objective and universal.
What insights did you gain form looking at the various ratio : A. For the following ratios create trend charts for WFM for 10 years 2002 - 2011. Use ratio data from Morningstar online database: Current ratio, Average collection period, Debt/Equity, Times interest earned, and Operating profit margin. Use separ..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Examine of z transform to time domain, poles and zeros

Analysis of z transform to time domain, poles and zeros, From a given z transform X(z) = {1- z^-10}/{1 - z^-1} the discrete time domain form x(n) is deduced using complex manipulation and inverse transforms to arrive at x(n) = x(n-1) + u(n) - u(n-..

  Computing peak frequency deviation and carson''s rule

Calculating peak frequency deviation and Carson's rule bandwidth, A baseband signal has a frequency range from 50 Hz to 15.0 kHz. The signal is transmitted using frequency modulation. The FM transmitter has a modulation constant of 100 kHz per vol..

  Draw block diagram of a communication channel

Explain the characteristics of electromagnetic waves and application to communications systems and determine the signal spectra for the content of complex waveforms

  Explain one signaling element is used to represent

Bandwidth, In a given communications system, one signaling element is used to represent 64 bits. The required data rate is 1.789 Mbps.

  Define mobile communications base station

In a typical mobile communications base station (or cell site), a radio frequency (RF) signal is amplified in the base station and then sent (over cable) to the antennas at the top of the tower.

  Derive a suitable sequential circuit

A sequential circuit has two inputs w 1 and w 2 , and an output, z. Derive a suitable circuit for the given condition.

  Determine ideal impulse response using inverse discrete-time

Determine ideal impulse response using inverse discrete-time Fourier transform. An ideal low-pass filter is described in the frequency-domain by

  Determine the resistivity of the wire

And how long it will take to reach that temperature assuming no heat lost in the process and comments on your results and may research the properties of nichrom wire to determine the resistivity of the wire

  Frequency range and local oscillator frequency

Frequency Range, Local Oscillator Frequency, Image Frequency, and Attenuation, A radio receiver for the AM broadcast band covers the frequency range 550 to 1600 kHz. The IF frequency is 455 kHz and the local oscillator is above the received signal..

  Define the gain of the antennas must be increased

The gain of the antennas must be increased when the TDMA system described in part (d) is used because the bit rate is higher than with FDMA and the noise power in the receiver is therefore higher

  Explain absorption loss of metal shielding

Absorption loss of metal shielding, A plane metal shield offers an absorption loss of 30 dB at a frequency of 10 kHz to normally incident radiated emission.

  Write down the principle of energy conversion

Write down the principle of energy conversion and give an example for single and double excited system.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd