Explain instantaneous voltage and current of capacitor

Assignment Help Electrical Engineering
Reference no: EM13139915

Instantaneous voltage and current of capacitor

The current flowing through a 5 F capacitor is i=3e^-2t. What is the voltage as a function of time, if the initial voltage is zero?

The voltage across a 2F capacitor is v = 20e^-4t volts. What is the instantaneous power?

Reference no: EM13139915

Questions Cloud

Problem will cause and how should difficulty be resolved : The smallest quantity in a cell is minus 35, but two different cells with minus signs have 35 units in them. What problem will this cause and how should this difficulty be resolved?
Profitable business under certain conditions : Her other projections include an initial inventory of $15,000, assembly training for $2,500, cost of goods sold (COGS) approximately $35,000, selling expenses of $9,000 and general and administrative expenses of $7,000. She expects to pay 25% of h..
What is v/cv and vc/v : what is V/CV and VC/V
How much nh3 could be produced : 1.0 mol of CaCN2 and 1.0 mole of water are mixed together: CaCN2 + 3H2O → CaCO3 + 2NH3 How much NH3 could be produced?
Explain instantaneous voltage and current of capacitor : Instantaneous voltage and current of capacitor, The current flowing through a 5 F capacitor is i=3e^-2t. What is the voltage as a function of time, if the initial voltage is zero?
What amount should be shown for buildings on consolidate : Hanson had buildings with a book value of $1,878,000 and a fair value of $2,160,000. What amount should be shown for buildings on the consolidated balance sheet dated December 31, 2011? 106.
Calculate the deadweight loss due to health insurance : Explain asymmetric information, moral hazard, and adverse selection within the context of health care sector and how many units of health care would be consumed if the patient had health insurance
An acrostic poem for clinton : An acrostic poem for CLINTON
Confidence interval of average of lenghs of movie : Four movies are randomly selected. Their lenghts were 110, 96, 125, and 136 minutes. Find a 95% confidence interval of the average of the lenghs of the movie.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define the voltage and current in the laplace domain

The voltage and current in the Laplace domain for a certain system is given by V (s) = 1/12 1/s^2 +3, I(s) = s/s^2+3. Is this system best described as resistive, capacitive, or inductive?

  Processor development

Explain the process of processor development

  Define what is the maximum bandwidth of the low pass

What is the maximum bandwidth of the low pass filters at the receiving end of the link? What bandwidth would you recommend for the LPFs?

  Define a baseband sine wave signal with frequency

A baseband sine wave signal with frequency 4.0 kHz is modulated onto a carrier at 1.050 MHz using DSB-LC AM. What are the frequencies of the sidebands of the RF signal?

  Define energy of a moving charge

Energy of a moving charge, A region in space has an Electric field given by E = x(x^) - y(y^) + xy(z^) where (x^), (y^), (z^) indicate corresponding letter with caret on top of it.

  What is the symbol rate of the earth station transmissions

What is the symbol rate of the earth station transmissions? What is the bit rate of the earth station transmissions? What is the duration of the burst transmission from each earth station?

  Plot the swing curve for the machine

Calculate the critical clearing angle and plot the swing curve for the machine - What is the power angle at the end of the 10 cycles?

  Define what is the rf bandwidth occupied by signal

What is the RF bandwidth occupied by signal? What is the frequency range of the transmitted RF signal?

  Define the gain of the antennas must be increased

The gain of the antennas must be increased when the TDMA system described in part (d) is used because the bit rate is higher than with FDMA and the noise power in the receiver is therefore higher

  Explain a terrestrial radio link transmits a cdma signal

A terrestrial radio link transmits a CDMA signal from a base station using a spreading code with a chip rate of 1.0 Mchips per seconds. The message data rate of the signal is 10 kbps.

  Explain blank leading zeros in the tens digit of the display

Using Multisim, design a mod-100 BCD counter that drives a 2-digit, 7-segment display. The count sequence will be 0 through 99. Blank leading zeros in the tens digit of the display.

  Define finding values of a composite discrete time signal

Finding values of a composite discrete time signal, A discrete time signal x(n) = x(n-1) + x(n-3) with initial conditions x(0) = 0, x(1) = 1 and x(2) = 2 is examined and the first 51

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd