Explain fundamental periods versus discrete time

Assignment Help Electrical Engineering
Reference no: EM13227387

A signal x[n] is formed by sampling a signal x(t) = -4sin(200*pi*t) at a sampling rate of 400Hz. Graph x[n] over 10 fundamental periods versus discrete time. Then do the same for the sampling frequencies of 60 and 200Hz.

Reference no: EM13227387

Questions Cloud

Calculate the ration of the mean squared signal of noise : stochastic message signal, m(t), is transmitted down a (noiseless) cable channel by PCM, using an 8-bit code. If the ambient signal is equally likely to lie anywhere between its two extremes, (+/- mp), calculate the ration of the mean squared sign..
What is difference between a mission and vision statement : What is the difference between a mission and vision statement. Discuss why mission statements are important in performance improvement and why a solid mission statement (describing your goals) should be in place in the quality of health care manag..
Calculate the gain and bandwidth after the feedback : Single pole amp. has an open loop gain 10^6 and open loop bandwidth of 10Hz. If the feedback factor =1, calculate the gain and bandwidth after the feedback
How are the quality of health care and excellence : How are the quality of health care and excellence in customer service related to each other?
Explain fundamental periods versus discrete time : A signal x[n] is formed by sampling a signal x(t) = -4sin(200*pi*t) at a sampling rate of 400Hz. Graph x[n] over 10 fundamental periods versus discrete time. Then do the same for the sampling frequencies of 60 and 200Hz.
Determine the probability density function of xp : A Gaussian random process having a mean value of 2 and a variance of 4 is passed through an ideal half-wave rectifier. a) Let Xp (t) represent the random process at the output of the half-wave rectifier
What are four safeguards that erisa legislation specified : What are four safeguards that the ERISA legislation specified to address the many obstacles employees faced with pension plan funding? How did the Pension Protection Act add additional requirements to the protection of these plans?
Determine the voltage regulation for each field current : A dc separately excited generator runs at 1200 rpm. the rated current and voltages are 100 A at 240 V. The armature resistance is 0.15 (ohms). The open circuit magnetization characteristics at 1200 rpm are
What are some characteristics and provisions of the cost : What are some characteristics and provisions of the cost of living escalator clauses and wage reopener arrangements that are part of the unions' efforts to adjust to the lack of dependability the Consumer Price Index (CPI) has demonstrated for fut..

Reviews

Write a Review

 

Electrical Engineering Questions & Answers

  Discuss the trade-offs between fiber optic and satellite

Discuss the trade-offs between fiber optic and satellite communication in terms of costs, signal capacity, signaling method, interference, likelihood of failure and repair issues, multipoint capability, reconfiguration capability, and noise.

  Estimate the ratio of powers generated by the same speed

Suppose a turbine is used for generating electricity, estimate the ratio of powers generated by the same speed water and air. (Water density=1g/cm3, air density =1.2kg/m3)

  What are the values of parity bits for the first messages

There are two four bit messages, 1010 and 1110. The first one is appended with an odd parity bit, the second one with an even parity bit. What are the values of the parity bits for the first and second messages respectively.

  Calculate the efficiency of the motors at the conditions

Based on these equations, determine the maximum power point. This is the value of and T that result in maximum power. State the power and the (,T) values. Do not assume this happens at 0.5T. The best way to do this is to make an Excel spreadsheet.

  Calculate the noise specification given snr

3. For a simulated inductor application, to yield L = 75mH, R1 = 3kohm, and C1 = 200uF, determine required value of R2 4. For a constant current generator, with a saturation voltage = 20V and a current reference of 30mA, calculate RLmin.

  What is the approximate discrete-time equation

What is the approximate discrete-time equation the models the continuous-time impulse response for fs=1kSa/s and RC=10^-2?How to solve this problem?

  What is the value of the capacitor

An inductive circuit of 50 ohm resistance and 0.08H inductor are connected in series with a capacitor across a 200-V 50-Hz supply. The current is 3.8A leading. What is the value of the capacitor

  What is the minimum number of bits required

What is the minimum number of bits required to represent each of the following decimal numbers: 10, 1000, 100,000, and 1,000,000?

  Generating multivariate random variables

Generate a new random variable X with pdf fX. Specifically, we want to generate a Gaussian random variable and relationship between Rayleigh and Gaussian distributions.

  Need for radical future plans

Need for radical future plans to alleviate the very real problem we are faced with in New Zealand and address this problem, by providing an answer to Transpower

  Define write-back write allocate

How do we deal with a L1 cache that is Write-back Write allocate, and the L2 cache, which is a Write-through Write no-allocate?

  Calculate the maximum value of k for stability

A sampled-data system such as that presented in problem (i) has a sampling period T = 0.05s and has G(z) = K (z3 + 10.3614z2 + 9.758z + 0.8353) / (z4 - 3.7123z3 + 5.1644z2 - 3.195z + 0.7408) 1. Determine K when the two real poles break away from the ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd