User Account

All Pages

Explain a non-inverting operational amplifier circuit

Assignment Help Electrical Engineering
Reference no: EM13227161

A non-inverting operational amplifier circuit is constructed to have a gain of 100 with an input signal of 1 kHz. Would you expect the circuit to have the same gain with the input signal of 1 MHz?

Reference no: EM13227161

Questions Cloud

How many fm radio stations could be accommodated in channel : An ordinary broadcast television channel has a bandwidth of 6 MHz. How many FM radio stations (with a bandwidth of 200 kHz each) could be accommodated in one television channel using FDM
Compare the human resources philosophy of two companies : Compare the human resources philosophy of two companies from the same industry. Comparison should include their similarities, differences and at least one item that gives that company a competitive advantage.
Explain reaction of phosphorous acid and potassium hydroxide : For the reaction of phosphorous acid (H3PO3) and potassium hydroxide (KOH), write (a) the balanced molecular equation, (b) the ionic equation and (c) the net ionic equation.
Find on the internet protected by copyright law : In your opinion, based on the Law you have read.(and be sure to reference the Law), are publications which you find on the Internet protected by Copyright Law?
Explain a non-inverting operational amplifier circuit : A non-inverting operational amplifier circuit is constructed to have a gain of 100 with an input signal of 1 kHz. Would you expect the circuit to have the same gain with the input signal of 1 MHz
How does storage contribute to the time value of goods : How does storage contribute to the time value of goods? Explain.
List and describe the strategies : List and describe the strategies that can be used to overcome resistance to change.
What is the worst-case propagation delay for the circuit : Design a 4-bit circuit for 2s-complement, base on the formula below, using only inverters, 2 input AND gates and 2 input OR gates. Design your circuit to be as fast as possible. What is the worst-case propagation delay for this circuit
How does one avoid infringing those rights in the future : What rights, if any, are infringed by not referencing Internet sources, and how does one avoid infringing those rights in the future? (If you did indeed reference Internet sources in any of your answers sources, answer this question as if you had ..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the noise on the output as percent fs

A system is needed to measure flow, which continuously cycles between 20 and 30 gal/min with a period of 30 sec. The required output is a voltage varying from -2.5 to +2.5 V for the cycling flow range. The sensor to be used has a transfer function..

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Find the overall gain gv and the equivalent circuit

Two amplifiers(CS) connected in cascade. The input voltage to the first stage has a source voltage Vsig and Rsig= 100KOhm. Rv=10KOhm AND IS CONNECTED TO THE DRAIN OF THE SECOND STAGE. BOTH TRANSISTORS HAVE Id=.25mA and Vov=.25V

  Find when the triggering angle is greater than 140 degrees

The average voltage across the load when the triggering angle is 140 degrees. Keep in mind that the conduction is incomplete when the triggering angle is greater than 140 degrees.

  Define tune pi parameters

Tune PI Parameters, Question: Given are the facts that Gc and Gp(s) are in series and Gp(s) = (K * Km) / [s[(Ls+R)(Js+b) + K^2m)]].

  What is the net resistance of the cone from top to bottom

A truncated cone has a height of 50cm. The circular faces on the top and bottom have radii of 20 mm and 1mm, respectively. If the material from which the solid cone is constructed has a conductivity sigma of 2 x 10^6 S/m.

  Calculate the total apparent power supplied by the source

A three-phase transmission line having a reactance of 120 ohms per phase is connected to a wye-connected load whose resistance is 160 ohms per phase. If the supply volatge is 70kV line-to-line, calculate a) The line-to-neutral voltage per phase.

  Determine the bit error rate performance

A signal is modulated by BPSK and transmitted over an AWGN channel. At the receiver, the bit error rate performance is 0.001

  Determine the left triceps muscle force

Determine the left triceps muscle force (Ftri), elbow joint reaction force (Rj) required to hold this position along with any ground reaction forces (Rg) and/or reaction moments (Mg) in the hand. Show all necessary free body diagrams along with th..

  Where should substation be located to minimize the losses

Three towns A, B & C are situated at the corners of an equivalent triangle of side 30 km. It is proposed to supply power to extent of 30 MW, 10 MW, 20 MW to A, B & C respectively from one substation. Where should substation be located to minimize ..

  How the half-adder can be constructed just with nand gates

HALF-ADDER: S = XY' + X'Y , C = XY (These are the outputs) 1. From the equation given for half-adder, develop an equation for which the half-adder can be constructed just with NAND gates. Draw the circuit as per the equation obtained.

  What are the four characteristic parameters

What are the four characteristic parameters of transmission line? Which parameter is used to calculate the real loss? Which parameter is used to calculate the charging current? Which parameter is almost negligible and why?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd